HPA576 Datasheet, PDF (1/1 Pages) EUROQUARTZ limited – 7x5mm SMD 6 pad

EURO QUARTZ
DESCRIPTION
HPA576 series LVPECL output oscillators cover the frequency range
60MHz to 320MHz. The part utilizes a crystal operating in third
overtone mode (Non-PLL)
SPECIFICATION
Frequency Range:
60.0MHz to 320.0MHz
Output Logic
LVPECL
Phase Noise:
See table
Frequency Stability:
See table
Operating Temp Range
Commercial:
-10° to +70°C
Industrial:
-40° to +85°C
Input Voltage:
+2.5VDC or +3.3VDC ±5%
Output Voltage
High '1':
Vdd -1.025V min.
Low '0':
Vdd -1.620V max.
(RL = 50W to Vdd -2.0V)
Rise/Fall Times:
0.25ns typical
(20% Vdd to 80% Vdd)
Current Consumption:
75mA max. at 212.50MHz
Load:
50W into Vdd-2.0V
Start-up Time:
5ms typ., 10ms max.
Duty Cycle:
50%±5% (at Vdd -1.3V)
Input Static Discharge Prot: 2kV min.
Storage Temperature Range: -55°C to +150°C
Ageing:
±3ppm per year max., ±2ppm
thereafter. At T amb +25°C
Enable/Disable
No connection:
Both outputs enabled
Disable:
Both outputs are disabled when
control pad is taken below 0.3V
referenced to ground. Oscillator is
always 'on'. (Special request -
oscillator is off when disabled.)
Enable:
Both Outputs are enabled when
control pad is taken above 0.7 Vcc
referenced to ground.
ABSOLUTE MAXIMUM RATINGS
(Permanent damage may be caused if operated beyond these limits.)
Supply Voltage Vdd:
+4.6V max.
Input Voltage Vi:
Vss -0.5 min., VDD +0.5V max.
Input Voltage Vo:
Vss -0.5 min., Vdd +0.5V max.
STABILITY OVER TEMPERATURE RANGE
Stability
±ppm
25
50
100
25
50
100
Temperature Range Order Code
°C
-10 to +70
A
-10 to +70
B
-10 to +70
C
-40 to +85
D
-40 to +85
E
-40 to +85
F
JITTER
Integrated Phase Jitter:
(12kHz to 20MHz)
Period Jitter (RMS):
Period Jitter (peak to peak):
0.25ps typical at 155.520MHz
3.0ps typical at 155.520MHz
21ps typical at 155.520MHz
HPA576 LVPECL OSCILLATORS
7x5mm SMD 6 pad
OUTLINE & DIMENSIONS
PHASE NOISE (155.250MHz)
Offset
dBc/Hz
10Hz
100Hz
1kHz
10kHz
100kHz
1MHz
10MHz
-65
-95
-120
-128
-122
-120
-140
PART NUMBERS
HPA576 oscillator part numbers are derived as follows:
Example:
3HPA5762-A-250.000
Supply Voltage
3 = 3.3VDC
25 = 2.5VDC
Series Designation
Package Style
5761 or 5762
Stability Code
(See table)
Frequency
EUROQUARTZ LIMITED Blacknell Lane CREWKERNE Somerset UK TA18 7HE
Tel: [phone] Fax: [phone] Email: [e-mail] www.euroquartz.co.uk