G1116 Datasheet, PDF (2/4 Pages) GTM CORPORATION – 0.6A Low Dropout Positive Adjustable or Fixed-Mode Regulator

Block Diagram
ISSUED DATE :2006/06/06
REVISED DATE :
Pin Descriptions
Name I/O Pin#
Adj (GND)
1
Vout
O
2
Vin
I
3
Function
A resistor divider from this pin to the Vout pin and ground sets the output voltage
(Ground only for fixed mode)
The output of the regulator. A minimum of 10uF capacitor (0.15 ESR 20 )
must be connected from this pin to ground to insure stability.
The input pin of regulator. Typically a large storage capacitor (0.15 ESR 20 )
is connected from this pin to ground to insure that the input voltage does not sag
below the minimum dropout voltage during the load transient response. This pin
must always be 1.3V higher than Vout in order for the device to regulate properly.
Absolute Maximum Ratings
Symbol
Parameter
VIN
DC Supply Voltage
PD
Power Dissipation
TST
Storage Temperature
TOP
Operating Junction Temperature Range
Ratings
-0.3 to 12
Internally Limited
-65 ~ + 150
0 ~ + 150
Unit
V
к
к
G1116
Page: 2/4