UG133 Datasheet, PDF (9/17 Pages) List of Unclassifed Manufacturers – CPT112S SLEXP8008A Kit

UG133: CPT112S SLEXP8008A Kit User's Guide
Peripherals
5.3 Buzzer
The device features a buzzer to provide feedback to the user when using the device. The board's buzzer is located to the bottom left of
the capacitive sense touch pads and is connected to the CPT112S on the BUZZER pin.
The buzzer can be configured to be active or inactive when the touch pads are touched using [Xpress Configurator] in Simplicity Stu-
dio.
The buzzer feature can also be disabled using [Xpress Configurator]. To use the BUZZER pin as a capacitive sensing input, unsolder
the R29 resistor to disconnect the Buzzer circuitry from the pin.
CS11 / BUZZER
BUZZER
Buzzer
CPT112S
Device
Figure 5.3. Buzzer
silabs.com | Smart. Connected. Energy-friendly.
Rev. 0.1 | 8