MINI57TDE Datasheet, PDF (9/131 Pages) List of Unclassifed Manufacturers – 32-bit Microcontroller

Mini57
- Supports software selectable slew rate control
- GPIO built-in Pull-up/Pull-low resistor for selection
 Timer
- Provides two channel 32-bit Timers; one 8-bit pre-scalar counter with 24-bit up-
timer for each timer
- Independent clock source for each timer
- Provides One-shot, Periodic, Toggle and Continuous operation modes
- 24-bit up counter value is readable through CNT (Timer Data Register)
- Provides trigger counting/free counting/counter reset function triggered by
external capture pin or internal comparator signal
- Supports event counter function
- Supports Toggle Output mode
- Supports wake-up from Idle or Power-down mode
- Timer0, Timer1 and Systick provided with Continuous capture function to
capture at most 4 edges continuously on one signal
 Continuous Capture
- Timer0, Timer1 and Systick have support Continuous capture function can
Continuous Capture 4 edge on one signal
 Enhanced Input Capture
- One unit of 24-bit input capture counter
- Capture surce:
 I/O inputs: ECAP0, ECAP1 and ECAP2
 PWM Trigger
 ADC Trigger
 WDT (Watchdog Timer)
- Programmable clock source and time-out period
- Supports wake-up function in Power-down mode and Idle mode
- Interrupt or reset selectable on watchdog time-out
 PWM
- Supports a built-in 16-bit PWM clock generators, providing six PWM outputs or
three complementary paired PWM outputs
- Shared same as clock source, clock divider, period and dead-zone generator
- Supports group/synchronous/independent/ complementary modes
- Supports One-shot or Auto-reload mode
- Supports Edge-aligned and Center-aligned type
- Supports Asymmetric mode
- Programmable dead-zone insertion between complementary channels
- Each output has independent polarity setting control
Apr. 06, 2017
Page 9 of 131
Rev.1.00