|
SGP12A Datasheet, PDF (8/9 Pages) List of Unclassifed Manufacturers – GPS SMT Patch Antenna | |||
|
◁ |
5. Antenna Recommended Soldering Conditions
5.1 Flux, Solder
⢠Use rosin-based flux. Donât use highly acidic flux with halide content exceeding 0.2wt%(chlorine conversion value).
⢠Use Sn solder.
5.2 Reflow Soldering Conditions
⢠Pre-heating should be in such a way that the temperature difference between solder and product surface is limited to 150â max.
Cooling into solvent after soldering also should be in such a way that temperature difference is limited to 100â max.
Unwrought pre-heating may cause cracks on the product, resulting in the deterioration of products quality.
Temp(°C)
240 °C
230 °C
180 °C
5 sec (Peak 245°C)
0° C
60-120sec
10-30sec
Time (s)
5.3 Reflow with Soldering Iron
⢠The following conditions must be strictly followed when using a soldering iron.
Pre-heating
Tip temperature
Soldering iron output
Soldering time
150°, 1 min
290° max
30w max
3 second max
SPE-11-8-136/D/SS | page 8 of 9
|
▷ |