PMS0603-005 Datasheet, PDF (8/28 Pages) List of Unclassifed Manufacturers – Surface Mount Polymer PTC PMS Series, 0603 Size

Rev. Feb. 2014
1. Recommended reflow methods: IR, hot air oven, nitrogen oven.
2. Recommended maximum paste thickness: 0.25mm (0.010 inch).
3. Devices can be cleaned using standard industry methods and solvents.
4. Soldering temperature and time should not exceed the recommended conditions.
Note: If reflow temperatures exceed the recommended profile, devices may not meet the performance
requirements.
Caution: Operation beyond the rated voltage or current may result in rupture electrical arcing or flame.
WARNING:
 Operation beyond the maximum ratings or improper use may result in device damage and
possible electrical arcing and flame.
 The devices are intended for protection against occasional over-current or over-temperature
fault conditions and should not be used when repeated fault conditions or prolonged trip events
are anticipated.
 Contamination of the PPTC material with certain silicon based oils or some aggressive solvents
can adversely impact the performance of the devices.
 Device performance can be impacted negatively if devices are handled in a manner inconsistent
with recommended electronic, thermal and mechanical procedures for electronic components.
 Operation in circuit with a large inductance can generate a circuit voltage (L di/dt) above the
rated voltage of the PPTC device.
458 Shenhu Road, Suzhou Industrial Park, Jiangsu, P.R.C.
Phone: [phone], Fax: [phone]
www.aemchina.com
4