NANO102ZB1AN Datasheet, PDF (78/100 Pages) List of Unclassifed Manufacturers – Nano102/112 Series

NuMicro Nano102/112 Datasheet
8 POWER COMSUMPTION
Part No
Test Condition
Operating Mode:
CPU run while(1) in FLASH ROM
Clock = 12MHz Crystal Oscillator
Disable all peripheral
Set LDO output = 1.6V
Idle Mode:
CPU stop
Clock = 12MHz Crystal Oscillator
Disable all peripheral
Set LDO output = 1.6V
Operating Mode:
CPU run while(1) in FLASH ROM
Clock = 12MHz Internal RC Oscillator
Disable all peripheral
Set LDO output = 1.6V
Idle Mode:
CPU stop
Clock = 12MHz Internal RC Oscillator
Disable all peripheral
Set LDO output = 1.6V
VDD CPU clock Current
3.3V
12 MHz
1.89mA
157uA/MHz
3.3V 12 MHz
800uA
67uA/MHz
3.3V
12 MHz
1.65mA
137uA/MHz
3.3V 12 MHz
560uA
46uA/MHz
RTC + LCD Mode: (RAM retention) ^{InternL C-Type}
(Power down with LXT and LCD ^{(With internal Charge pump)}
Nano102/112
series
enable)
CPU stop
Clock = 32.768KHz Crystal
Oscillator
InternL R-Type
(With internal
resistor ladder)
200kΩ
300kΩ
400kΩ ^{3.3V Stop}
Disable all peripheral except RTC
and LCD circuit. Without panel ^{External C-Type}
loading
(With 0.1uF cap. ladder)
Set LDO output = 1.6V
Only for Nano112 LCD series
External R-type
(With 1MΩ resister ladder)
9.5uA
8.3uA
6.4uA
5.5uA
2.5uA
3.7uA
RTC Mode: (RAM retention)
(Power down with LXT enable)
CPU stop
Clock = 32.768KHz Crystal Oscillator
Disable all peripheral except RTC circuit
Set LDO output = 1.6V
Power Down Mode: (RAM retention)
CPU and all clocks stop
Set LDO output = 1.6V
Wake-Up time from Power Down Mode
Clock = Internal 12 MHz RC Oscillator
(from wake-up event to first CPU core valid clock)
Wake-Up time from Power Down Mode
Clock = Internal 12 MHz RC Oscillator
(from interrupt event to interrupt service routine first
instruction)
3.3V Stop
1.5uA
3.3V Stop
0.65uA
3.3V 12 MHz
6us
3.3V 12 MHz
7us
May 08, 2013
Page 78 of 100
Revision 1.01