W11800 Datasheet, PDF (6/7 Pages) List of Unclassifed Manufacturers – Hydraulic Rod and Bar Cutters

MISCELLANEOUS INFORMATION
Ordering Replacement Parts
Order replacement parts through your Cooper Tools Distributor. Care should be taken to give accurate information regarding part
numbers and descriptions. Include model numbers and serial numbers, as well. Although all parts are available at the factory,
we suggest customers stock spare blades, seals, filters and oil for minimum delay in maintaining their units.
Operating Hydraulic Pumps Below -25°F (-31°C)
Unless otherwise requested at time of purchase, all HKP pumps are supplied with a high quality hydraulic oil. Pour point -25°F
(-31°C) 150/165 viscosity SSU @ 100°F (38°C). When operating below -25°F, contact Cooper Tools Customer Service for oil
recommendation.
Factory Repair Service
HKP units may be returned to factory for repair and reconditioning at any time. A free inspection and estimate
of repair charges will be supplied if requested. All returns must be made by prepaid transportation.
Installation Recommendations
IMPORTANT: Electrical connections on cutterhead and hydraulic hose are for low voltage control only. DO NOT PLUG
CONTROL HANDLE INTO MAIN POWER SUPPLY. The switches and wiring are designed for relay control only.
HE2200 series single phase Power Pack units are factory wired to run in counterclockwise direction and can be plugged into
any outlet with proper power supply. Three phase units must be wired into customer’s system. Be sure to wire so unit runs
counterclockwise.
HKE102A, HKE302A, HKE402A, HKE602B and T5102 Hydraulic Power Sources are supplied in three phase only and can be
wired to operate in either direction.
Try to install units so that hoses and wiring are not accessible to damage by fork lifts or other handling equipment.
When installing pumping unit overhead, be sure to have both cutterhead and hoses well below the pump. Do not loop hoses
overhead as air pockets will result in slow reaction. Speed of cut should be approximately that indicated on the POWER TOOL
SELECTOR CHART. If unit is cutting slower than indicated, DO NOT ADJUST RELIEF VALVE. THE PRESSURE SETTING
WILL NOT AFFECT THE SPEED.
We recommend checking all connections for leaks, check for voltage drop or contact factory for assistance.
Power Tool Hoses & Accessories
• All HKP hydraulic hoses are made from the finest oil-and abrasion-resistant materials.
• This hose style is also offered in 1/4" or 3/8"
• Hoses are 2-ply rated, reinforced with two braids of high tensile steel wire and covered with oil and weather resistant rubber
• MSHA approved, 2-wire steel braid with 3/8" (10mm) – 18 NPTF fittings
• Order only enough hose to fit your particular application. Using to much hose, slows operator and production
• All control wire hoses come complete with 3-wire, twist-lock connectors for low voltage control only
• Couplings not included with hoses
• Special hoses are available upon request
DANGER Never use any H.K. Porter cutters on
energized circuits, wire, or cable.