TC-550RVN2 Datasheet, PDF (6/16 Pages) List of Unclassifed Manufacturers – 550W+550W for IPC-Computer

3.5.OUTPUT
3.5.1. Stand-by power
The system shall provide a standby output of 5V +/- 5% with a current sourcing capability of
3.0A. The ripple and noise of this output shall be less than 50mVp-p. The output shall be
active whenever AC power is applied to the unit. *PSON shall have no effect on this output.
3.5.2. Output current capacity
Each of the 1+1 redundant power supply module shall be capable of supplying the output
currents of as below subject to the listed conditions and a total output power of 550watts.
Due to the active current share, the actual maximum steady state current from each output
shall be about half of the maximum current specified.
OUTPUT OUTPUT CURRENT
REGULATION
OUTPUT
VOLTAGE
TC-550RVN2
LOAD LINE RIPPLE & NOISE max. (P-P)
Min.
Max.
+5V
1A
32A
±5％ ±1％
50mV
+3.3V
1A
25A
±5％ ±1％
50mV
+12V
3A
38A
±5％ ±1％
70mV
-12V
0A
1A
±5％ ±1％
70mV
+5SB
0.1A
3A
±5％ ±1％
50mV
REMARKS:
1.Total Max output of +5V AND +3.3V not exceed 200W
2.Power module Total output power not exceed 550W forTC-550RVN2
3.Noise bandwidth is from DC to 20MHz.
3.5.3. Output voltage rise time
The rise time shall be less than 20 ms measured from 10% to 90%.
3.5.4. Output voltage hold up time
Upon loss of an ac input at any input voltage between 115/230V, the output
voltages of the system shall remain in regulation for at least 16 ms at full output
loads.
⑥