PI60-04-FPIZ Datasheet, PDF (6/26 Pages) List of Unclassifed Manufacturers – 8V to 36Vin, 15A Cool-Power ZVS B uck Regulator

PI33XX-X1
PI3311-X1 (1.0 Vout) Electrical Characteristics
Specifications apply for -40C < T_J < 125C, Vin =24V, L1=80nH (Note 1) unless other conditions are noted.
Parameter
Input Specifications
Input Voltage
Symbol
V_{IN_DC}
Input Current
Input Current At Output Short
(fault condition duty cycle)
I_{IN_DC}
I_{IN_Short}
Input Quiescent Current
I_{Q_VIN}
Input Voltage Slew Rate
Output Specifications
Output Voltage Total Regulation
Output Voltage Trim Range
Line Regulation
Load Regulation
V_{IN_SR}
V_{OUT_DC}
V_{OUT_DC}
∆V_OUT(∆V_IN)
∆V_OUT(∆I_OUT)
Output Voltage Ripple
V_{OUT_AC}
Continuous Output Current Range
Current Limit
Protection
I_{OUT_DC}
I_{OUT_CL}
VIN UVLO Start Threshold
VIN UVLO Stop Threshold
VIN UVLO Hysteresis
VIN OVLO Start Threshold
VIN OVLO Stop Threshold
VIN OVLO Hysteresis
V_{UVLO_START}
V_{UVLO_STOP}
V_{UVLO_HYS}
V_{OVLO_START}
V_{OVLO_STOP}
V_{OVLO_HYS}
VIN UVLO/OVLO Fault Delay Time
t_{f_DLY}
VIN UVLO/OVLO Response Time
Output Over Voltage Protection
Over-Temperature Fault Threshold
Over-Temperature Restart
Hysteresis
t_f
V_OVP
T_OTP
T_{OTP_HYS}
Note 1: All parameters reflect regulator and inductor system
performance. Measurements were made using a standard PI33XX
evaluation board with 3x4” dimensions and 4 layer, 2oz copper.
Refer to inductor pairing table within Application Description
section for specific inductor manufacturer and value.
Note 2: Regulator is assured to meet performance specifications
by design, test correlation, characterization, and/or statistical
process control.
Min Typ Max Units Conditions
8
24
36
V
Minimum 1mA load
required
740
mA
Vin = 24V, T_C = 25°C,
Iout=15A
25
mA Note 2.
2
2.5
mA
Disabled
Enabled (no load)
1
V/μs Note 2.
0.987
1.0 1.013
V Note 2.
1.0
1.4
V Note 3.
0.10
% @25°C, 8V<Vin<36V
0.10
% @25°C, 0.5A<Iout<15A
45
mVp-p
Iout=5A, Cout=8x100μF,
20MHz BW Note 4.
0.001
15
A Note 2.
18.0
A
7.10 7.60 8.00
V
6.80 7.25 7.60
V
0.35
V
36.1 37.6
V
37.0 38.4
V
0.8
V
128
Cycles
Number of the
switching freq cycles
500
ns
20
% Above V_OUT
130 135 140
°C Note 2.
30
°C
Note 3: Output current capability may be limited and other
performance may vary from noted electrical characteristics when
switching frequency or Vout is modified.
Note 4: Refer to Output Ripple plots.
Note 5: Refer to Load Current vs. Ambient Temperature curves.
Note 6: Refer to Switching Frequency vs. Load current curves.
vicorpower.com
800 735.6200
Rev 1.2
07/2013
Cool-Power^®
Page 6 of 26