GDM128128A Datasheet, PDF (5/14 Pages) List of Unclassifed Manufacturers – SPECIFICATIONS OF LCD MODULE

GDM128128A
If a STA7=0 command is sent to the T6963c during this period, the T6963C enters wait
status. If a status check is not carried out in this state before the next command is sent,
there is the possibility that the command or data will not be received.
Setting data
When using the T6963C, first set the data, and then set the command. Procedure for
sending a command:
a). The case of 1 data
b) the case of 2 data
send command
send command
STA0.1 status check
data write
status check
command write
end
status check _STA0.1
data write
status check
data write
status check
command write
end
(a)
(b)
Note:
When sending more than two data, the last datum (or last two data) is valid.
V: A
5/15
2001/12/05