05003 Datasheet, PDF (5/8 Pages) List of Unclassifed Manufacturers – CAPACITORS, FIXED, CERAMIC, CHIP, 0402, HIGH FREQUENCY, BP

3.3.3 Dissipation factor (+25°C). When measured at the frequency and voltage specified in 3.3.2, the dissipation factor shall be 0.05
percent.
3.3.4 Insulation resistance. At +25°C: minimum of 100,000 megohms or 1,000 megohm-microfarads, whichever is less.
At +125°C: minimum of 1,000 megohms or 10 megohm-microfarads, whichever is less.
3.4 Solderability. In accordance with MIL-PRF-55681, except the sample size shall be 5 pieces with zero defectives permitted.
3.5 Moisture resistance. In accordance with MIL-PRF-55681, with the following exceptions:
a. Polarizing voltage shall be rated voltage.
b. Testing may be performed on chips with a larger width and/or length as long as they are cut from the same wafer(s) as those used
for production.
3.6 Marking. As a minimum, marking shall be on the package due to the small size of the chips. The package marking shall be in
accordance with MIL-STD-1285, except the PIN shall be as specified in paragraph 1.2 with manufacturer’s name or CAGE code and date
code. The manufacturer may, at their option, mark some information on the chips. Suggested marking is the 2 digit EIA capacitance code.
3.7 Manufacturer eligibility. To be eligible for listing as an approved source of supply, a manufacturer shall be listed on the MIL-PRF-
55681 Qualified Products List for at least one part, or perform the group A and group C inspections of MIL-PRF-55681on a sample of
parts agreed upon by the manufacturer and DLA Land and Maritime-VA.
3.8 Certificate of compliance. A certificate of compliance shall be required from manufacturers requesting to be an approved source of
supply.
3.9 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or environmentally preferable materials should
be used to the maximum extent possible provided that the material meets or exceeds the operational and maintenance requirements, and
promotes economically advantageous life cycle costs.
3.10 Workmanship. In accordance with MIL-PRF-55681.
4. VERIFICATION
4.1 Qualification inspection. Qualification inspection is not required.
4.2 Conformance inspection.
4.2.1 Inspection of product for delivery. Inspection of product for delivery shall consist of all tests specified in group A of MIL-PRF-55681.
ESR testing and PPM testing and calculation are not applicable. When optional group C testing is requested, terminal strength and series
resonance are not applicable.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the contract or order (see 6.2). When
packaging of materiel is to be performed by DoD or in-house contractor personnel, these personnel need to contact the responsible
packaging activity to ascertain packaging requirements. Packaging requirements are maintained by the Inventory Control Point’s
packaging activities within the Military Service or Defense Agency, or within the military service’s system commands. Packaging data
retrieval is available from the managing Military Department’s or Defense Agency’s automated packaging files, CD-ROM products, or
by contacting the responsible packaging activity.
DEFENSE SUPPLY CENTER, COLUMBUS
COLUMBUS, OHIO
SIZE
A
CODE IDENT NO.
037Z3
REV C
DWG NO.
05003
PAGE 5