UM1974 Datasheet, PDF (49/62 Pages) List of Unclassifed Manufacturers – STM32 Nucleo-144 board

UM1974
Hardware layout and configuration
Table 16. NUCLEO-F429ZI pin assignments (continued)
Connector Pin
Pin
name
Signal name
STM32
pin
Function
Remark
CN10
4
D6
6
D5
8
D4
10
D3
12
D2
14
D1
16
D0
18 D42
20 D41
22 GND
24 D40
26 D39
28 D38
30 D37
32 D36
34 D35
TIMER_A_PWM1
TIMER_A_PWM2
I/O
TIMER_A_PWM3
I/O
USART_A_TX
USART_A_RX
TIMER_A_PWM1N
TIMER_A_ETR
GND
TIMER_A_PWM2N
TIMER_A_PWM3N
I/O
TIMER_A_BKIN1
TIMER_C_PWM2
TIMER_C_PWM3
PE9
PE11
PF14
PE13
PF15
PG14
PG9
PE8
PE7
-
PE10
PE12
PE14
PE15
PB10
PB11
TIM1_CH1
TIM1_CH2
-
TIM1_CH3
-
USART6
TIM1_CH1N
TIM1_ETR
Ground
TIM1_CH2N
TIM1_CH3N
I/O
TIM1_BKIN1
TIM2_CH3
TIM2_CH4
Arduino
support
-
1. Refer to Table 11: Solder bridges for details.
2. PA7 is used as D11 and connected to CN7 pin 14 by default. If JP6 is ON, it is also connected to both
Ethernet PHY as RMII_DV and CN9 pin 15. In this case only one function of Ethernet or D11 could be
used.
3. PE2 is connected to both CN9 pin 14 (SAI_A_MCLK) and CN10 pin 25 (IO). Only one function can be used
at one time.
4. PB13 is used as I2S_A_CK and connected to CN7 pin 5 by default. If JP7 is ON, it is also connected to
Ethernet PHY as RMII_TXD1. In this case only one function of Ethernet or I2S_A could be used.
6.14
ST morpho connector
The ST morpho connector consists in male pin header footprints CN11 and CN12 (not
soldered by default). They can be used to connect the STM32 Nucleo-144 board to an
extension board or a prototype/wrapping board placed on top of the STM32 Nucleo-144
board. All signals and power pins of the STM32 are available on ST morpho connector. This
connector can also be probed by an oscilloscope, logical analyzer or voltmeter.
Table 17 and Table 18 show the pin assignment of each main STM32 on ST morpho
connector.
DocID028599 Rev 1
49/62
61