RFM65CW Datasheet, PDF (41/71 Pages) List of Unclassifed Manufacturers – ISM RECEIVER MODULE

ADVANCED COMMUNICATIONS & SENSING
RFM65CW
DATASHEET
Rx DATA
(NRZ)
Bit N-x =
Sync_value[x]
DCLK
Bit N-1 =
Bit N =
Sync_value[1] Sync_value[0]
SyncAddressMatch
Figure 24. Sync Word Recognition
During the comparison of the demodulated data, the first bit received is compared with bit 7 (MSB) of RegSyncValue1 and
the last bit received is compared with bit 0 (LSB) of the last byte whose address is determined by the length of the Sync
word.
When the programmed Sync word is detected the user can assume that this incoming packet is for the node and can be
processed accordingly.
SyncAddressMatch is cleared when leaving Rx or FIFO is emptied.
5.2.3.2. Configuration
z _{Size: Sync word size can be set from 1 to 8 bytes (i.e. 8 to 64 bits) via SyncSize in RegSyncConfig.}
z Error tolerance: The number of errors tolerated in the Sync word recognition can be set from 0 to 7 bits to via SyncTol.
z Value: The Sync word value is configured in SyncValue(63:0).
Note SyncValue choices containing 0x00 bytes are not allowed
5.2.4. Packet Handler
The packet handler is the block used in Packet mode. Its functionality is fully described in section 5.5.
5.2.5. Control
The control block configures and controls the full chip's behavior according to the settings programmed in the configuration
registers.
Tel: [phone] Fax: [phone] E-mail: [e-mail] http:/ / www.hoperf.com
Page 41