MF0 Datasheet, PDF (4/8 Pages) List of Unclassifed Manufacturers – Metal Film Resistors

6. DIMENSIONS
ψd
H
STYLE
MF0204
MF0207
L
ψD
L
3.4±0.3
6.3±0.5
ψD
1.9±0.2
2.4±0.2
H
28±2.0
28±2.0
Unit：mm
ψd
0.5±0.05
0.6±0.05
7. ENVIRONMENTAL CHARACTERISTICS
(1) Short Time Over Load Test
At 2.5 times of the rated voltage. ( If the voltage exceeds the maximum load voltage, the maximum load
voltage will be used as the rated voltage ) applied for 5 seconds, the resistor should be free from defects
after the resistor is released from load for about 30 minutes
Short Time Overload Voltage = 2.5* Power Rating × Resistance Value
The change of the resistance value should be within ± 0.25 % + 0.05Ω
(2) Dielectric Withstanding Voltage
The resistor is placed on the metal V Block. Apply a Table I dielectric withstanding between the
terminals connected together with the block for about 60 seconds.
The resistor shall be able to withstand without breakdown or flashover.
(3) Temperature Coefficient Test
Test of resistors above room temperature 100°C ± 2°C ( Testing Temperature 115°C to 130°C ) at the
constant temperature silicon plate for over 5 minutes. Then measure the resistance value.
The Temperature Coefficient is calculated by the following equation and its value should be within the
range of requested.
Re sistor Temperature Coefficient = ^{R − R0} × ¹ × 10⁶
R₀ t − t₀
R ＝ Resistance value under the testing temperature
R0 ＝ Resistance value at the room temperature
t ＝ The testing temperature
t_o ＝ Room temperature
(4) Insulation Resistance
Apply test terminal on lead and resistor body.
The test resistance should be high than 10,000M ohm.
Page-4