450-0053 Datasheet, PDF (31/42 Pages) List of Unclassifed Manufacturers – Integrated Transceiver Modules for WLAN 802.11 a/b/g/n, Bluetooth, Bluetooth Low Energy (BLE), and ANT

TiWi5 TRANSCEIVER MODULE
DATASHEET
AGENCY CERTIFICATIONS
FCC ID: TFB-TIWI501, 15.247
IC ID: 5969A-TIWI501, RSS 210
CE: Compliant to standards EN 60950-1, EN 300 328, EN 301 489, and EN 301 893
SAR: This wireless mobile and/or portable device has been shown to be compliant for localized specific
absorption rate (SAR) for uncontrolled environment/general exposure limits specified in ANSI/IEEE Std.
C95.1-1999 and had been tested in accordance with the measurement procedures specified in IEEE
1528-2003, OET Bulletin 65 Supp. C, RSS-102 and Safety Code 6.
AGENCY STATEMENTS
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
UNII devices operating within 5.15-5.25 GHz are to be restricted to indoor operations to reduce any
potential for harmful interference to co-channel MSS operations.
FCC CAUTION: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
The information in this document is subject to change without notice.
330-0042-R2.0
Copyright © 2011-2012 LS Research, LLC
Page 31 of 42