S-7070EB Datasheet, PDF (3/8 Pages) List of Unclassifed Manufacturers – ROTARY CODED SWITCHES (SMD)

COPAL ELECTRONICS
S-7000
ROTARY CODED SWITCHES (SMD)
˙STANDARD SPECIFICATIONS
Circuit type
BCD (Real code, complementary code)
BCH (Real code, complementary code)
Operating temperature range
Storage temperature range
−40 ~ 85 °C
Sealing
Net weight
Washable by “O” ring
Approx. 0.26 g (A or B type in top setting)
Approx. 0.28 g (C type in top setting)
Approx. 0.62 g (Side setting type)
˙MECHANICAL CHARACTERISTICS
No. of positions
6, 10, 16
Adjustment torque
Stepping angle
Solderability
20 mN·m {204 gf·cm} maximum
60° (6 positions)
36° (10 positions)
22.5° (16 positions)
245 ± 3 °C, 2 ~ 3 s
Soldering heat
Reflowɿ255 °C (Peak temperature)
ʢPlease refer to the profile belowʣ
Flow : 260 ± 3 °C, 5 ~ 6 s, two times maximum
Manual soldering : 350 ± 10 °C, 3 ~ 4 s
Shear (adhesion)
5 N {0.51 kgf}, 10 s
Substrate bending
Width 90 mm, bend 3 mm, 5 s, 1 time
Pull-off strength
5 N {0.51 kgf}, 10 s
{ } : Reference only
˙ELECTRICAL CHARACTERISTICS
Contact rating
Non-switching
Switching
Minimum
DC50 V 100 mA
DC5 V 100 mA
DC20 mV 1 μA
Contact resistance
Insulation resistance
Dielectric strength
100 mΩ maximum
100 MΩ (DC100 V) minimum
AC250 V, 60 s
˙ENVIRONMENTAL CHARACTERISTICS
Vibration
Amplitude 1.5 mm or Acceleration 98 m/s²,
10-500-10 Hz, 3 directions for 2 h each
Shock
Load life
490 m/s², 11 ms
6 directions for 3 times each
10000 steps minimum, DC5 V, 100 mA
Humidity (Steady state) 40 °C, Relative humidity 90 ~ 95 %, 240 h
High temperature exposure
85 °C, 96 h
Low temperature exposure
− 40 °C, 96 h
Thermal shock
− 40 (0.5 h) ~ 85 °C ( 0.5 h ), 5 cycles
ʪReflow profile for soldering heat evaluationʫ
(°C)
250
200
180 °C
150 150 °C
100
Peak
:
250
+5
0
°C
Over 230 °C
Pre Heating Zone
90 ± 30 s
30 ± 10 s
50
Heating time ^{Soldering Zone}
Reflow : two times maximum
˙ Specifications are subject to change without notice. Specifications in this catalog are for reference. The formal specification sheets will be submitted upon request.