CB-96-G1 Datasheet, PDF (3/5 Pages) List of Unclassifed Manufacturers – Carrier Board for

CB-96-G1
Data Sheet
Joystick Circuit
The The Joystick is a 5 position multi switch and
each position connects to a junction of a resistor
ladder network that forms a voltage divider.
uOLED-96-G1(SGC) Serial Display: The output of
the Joystick connects directly to the SWITCH pin.
Each Joystick position is interpreted as 1 of 5
buttons or switches.
uOLED-96-G1(GFX) 4DGL Display: The output of
the Joystick voltage divider connects directly to
the IO1 pin. The IO1 pin can be programmed as an
Analogue to Digital (A2D) converter input under
4DGL. Utilising the A2D feature, each individual
switch position voltage value can be read and
decoded. The IO1 pin of the display modules are
directly connected to the output of the joystick
voltage divider circuit.
Attaching the Display Module
The following images illustrate various ways of
attaching the OLED-96-G1 display modules to the
CB-96-G1 carrier board.
1 The Bare Board
2 Display Module Directly Soldered
3 Display Module via Sockets
4 Interfacing the uUSB-MB5/CE5
Joystick Circuit
Note: The uOLED-96-G1(SGC) (Serial Platform)
and the uOLED-96-G1(GFX) (4DGL Platform)
display modules are both similar electrically and
mechanically.
© 2011 4D Systems
www.4dsystems.com.au
Page 3 of 5