700D10896-348 Datasheet, PDF (3/4 Pages) List of Unclassifed Manufacturers – Power Ring Film CapacitorsTM

Power Ring Film CapacitorsTM
SBE Part 700D10896-348
Mechanical Mounting and Additional Thermal Notes:
This capacitor is optimized for extremely low self
inductance when connected to a suitable laminar bus
structure.When so connected, the capacitor is very
rigidly attached to such a structure and thus does not
necessarily need to be mounted to a chassis.However,
the capacitor case can be attached to an application
surface/heat sink, etc. if desired.When so mounted,
the capacitor can be part of the bus structure sup-
port.Use of thermal interface compound between the
capacitor case and application surface/heat sink will
assist with removal of capacitor and bus heat.Note
that the capacitor internal heating is VERY small, and
other bus structure heat sources are very likely signifi-
cantly higher than the heat added to the bus by the
capacitor.Capacitor dissipation is approximately 5W at
200Arms, from 1-100KHz.It is highly recommended to
use infrared thermal imaging from a system cold start
to determine the location and relative magnitude of
thermal input to the bus.The capacitor may well func-
tion as a thermal conduit for bus structure heat, and
it will be very possible that the capacitor internal hot
spot is less than the terminal temperature.
Thermal contour maps are available for some repre-
sentative conditions.
Layout Details:
NOTES:
1. All Hole Positions Inspected
2. All Dimensions Inspected Unless
Marked As Reference
7X 45.0°
6.868
Bolt Circle
A
REV.
01
02
Revisions
DESCRIPTION
Initial Release
Standardized Layout View
22.5°
C
16X M5X0.8 - 6H THRU
28 in-lbs MAX Torque
.020 A B C
B
8.746
Bolt Circle
CHG CHK APR
BY BY BY
-
-
-
AGH MGS MSB
DATE
-
12/14/2010
8.465
9.252
Bolt Circle
.663
4X .197±.005 THRU
Accepts 1/4" Plastite Screw
40 in-lbs MAX Torque
.020 M A B C
.040
16 Surfaces
A
1.000
.500
.280
NON-TOLERANCED DIMENSIONS ARE BASIC
.010 A B C
UNLESS OTHERWISE SPECIFIED:
ALL DIMENSIONS ARE IN INCHES
.260
2.154
SBE, INC.
81 PARKER ROAD
BARRE, VT 05641 USA
802.476.4146 FAX: [phone]
DETAIL A
PROPRIETARY AND CONFIDENTIAL
SCALE 1 : 1
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF SBE. ANY
REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF SBE IS PROHIBITED.
MATERIAL
TITLE
Power Ring Capacitor,
1000uF, 600VDC ^{GEOMETRIC TOLERANCING PER: Y14.5-2009}
DRAWN
CHECKED
ENG APPR.
MGS
DMB
MSB
11/12/2010 ^{DWG. NO.}
11/12/2010 ^700D348LV
FINISH
DO NOT SCALE DRAWING ^SIZE A ^REV 02 SHEET 1 OF 1
Contact SBE Inc. to discuss your specific requirements.
SBE reserves the right to amend design data
At the Leading Edge of Film Capacitor Technology®