CY8CKIT-036 Datasheet, PDF (23/48 Pages) List of Unclassifed Manufacturers – THERMAL MANAGEMENT EXPANSION

The example projects will be displayed in the Workspace Explorer window as shown in the
example below for the CY8CKIT-001 PSoC DVK:
Figure 4-9 Workspace Explorer View
„ Running the Example Firmware: CY8CKIT-001 PSoC DVK
Make sure the hardware has been configured according to the Hardware Setup section.
1. If this is the first time that the example project firmware is being programmed into PSoC, make
sure the TME EBK is not connected to the PSoC DVK
2. Apply 12 VDC power to the PSoC DVK
3. Attach the MiniProg3 first to a USB port on the PC and then to the PROG port on the
CY8CKIT-009 PSoC 3 Processor Module
4. In PSoC Creator, set the appropriate example project as active by right clicking on it in the
Workspace Explorer and selecting Set As Active Project
5. In PSoC Creator, select Debug > Program to program PSoC
6. Remove power from the PSoC DVK and attach the TME EBK to Port A of the PSoC DVK
7. The PSoC DVK and the TME EBK boards should be powered separately. Power the PSoC
DVK first
8. The TME EBK includes a 12V DC high-current power supply that is capable of supplying the
inrush current needed by the fans installed on that kit. Use that power supply connected to the
power connector (J13) and set the power jumper (J9) on the TME EBK board to “12V_EXT”
(the default setting)
9. If the TME EBK cannot be detected by PSoC, status debug messages will be displayed on the
LCD to assist with rectifying the problem
22