41727001X2X-3 Datasheet, PDF (21/37 Pages) List of Unclassifed Manufacturers – PC, HDMI, DISPLAY PORT INTERFACE CONTROLLER FOR TFT PANEL

Design Guideline for making VR circuitry :
Signal description / Notes :
1) R1 : 470ohm on board
2) RPOT is an external potentiometer (in-line dip
style) that can be plugged directly into CNC1 pins
3,4,5. RPOT must be supplied / installed by user.
3) BVR_B : Voltage tapped from “top” of
potentiometer, the node of R1 and RPOT.
4) BVR_WIP : Voltage tapped from wiper arm of
RPOT.
5) BVR_A : Voltage tapped from “bottom” of
RPOT.
Note : BVR_A voltage is left floating on the
controller board. To use this circuit, you need
to tie this point to a potential (usually GND,
available at CNC1 pin 6).
CNB1 – Backlight inverter connector: JST B5B-XH-A (Matching type : XHP-5)
PIN
SYMBOL
DESCRIPTION
1
GND
Ground
2
VBKL
+12VDC / 24VDC, backlight power supply (selected by JA3 & JA6)
3
BLCTRL
On/Off control (enable) – see JB2 & JB3
4
BVR_WIP
Brightness VR - WIP
5
BVR_A
Brightness VR A
CNC1 – Control switch, JST B12B-XH-A (Matching type : XHP-12)
PIN
SYMBOL
DESCRIPTION
1
PSWIN
Power button A
2
SW_ON
Power button B
3
BVR_A
Backlight Brightness VR pin A
4
BVR_WIP
Backlight Brightness R pin WIP
5
BVR_B
Backlight Brightness VR pin B (470 ohm resistor to +5V Vcc)
6
GND
Ground
7
MENU
OSD menu
8
-/LEFT
OSD -/Left
9
+/RIGHT
OSD +/Right
10
SEL_DN
OSD Select down
11
SEL_UP
OSD Select up
12
NC
No connection
The VR for brightness depends on the inverter. The main power load for On/Off is handled by a relay on the controller.
Example for circuit design :
1.)Choose RPOT = 10K
2.) Tie BVR_A to GND
3.) Circuit analysis gives BVR_WIP as the
following (see Figure 1)
BVR_WIP = 5 x (Rbc/10.47)
where BVR_WIP is in Volts.
And Rbc is the resistance from the wiper arm
to bottom of pot in Kohms.
To evaluate, plug in different values of Rbc :
Rbc
0
2.5 K
5K
7.5 K
10 K
BVR_WIP
0V
1.2 V
2.4 V
3.6 V
4.8 V
So this circuit could provide Brightness
adjust voltage ranging from 0V to 5V.
Page 21 of 36