THAT1512S08-U Datasheet, PDF (2/8 Pages) List of Unclassifed Manufacturers – Low-Noise, High Performance Audio Preamplifier IC

Document 600031 Rev 08
Page 2 of 8
THAT 1510/1512 Low-Noise
High Performance Audio Preamplifier IC
SPECIFICATIONS¹
Absolute Maximum Ratings^2,3
Positive Supply Voltage (VCC)
Negative Supply Voltage (VEE)
Input Voltage (VIN MAX)
Output Short-Circuit Duration (tSH)
+20 V
-20 V
VCC + 0.5V, VEE - 0.5V
Continuous
Lead Temp. (TLEAD) (Soldering 10 sec)
Operating Temperature Range (TOP)
Storage Temperature Range (TST)
Junction Temperature (TJ)
260 °C
-40 to +85°C
-40 to +125°C
150°C
Recommended Operating Conditions
Parameter
Positive Supply Voltage
Symbol
VCC
Conditions
Min
Typ
Max
+5
+20
Negative Supply Voltage
VEE
-5
-20
Units
V
V
Parameter
Supply Current
Input Bias Current
Input Offset Current
Offset Voltage
Output Stage Output Offset
Input Stage Input Offset
Total Output Offset
Input Voltage Range
Common Mode
Differential Mode
Differential Gain
Ref Input Voltage Range
Ref Input Impedance
Ref Input Gain to Output
Input Impedance
Electrical Characteristics²
Symbol
ICC, -IEE
Conditions
No signal
VCC = -VEE = 20V
1510
Min Typ Max
— 6.0 7.9
— — 8.0
IB
No signal; Either input — 4.8 14
connected to GND
IB-OFF
No signal
-1.4 — +1.4
1512
Min Typ Max
— 6.0 7.9
— — 8.0
— 4.8 14
-1.4 — +1.4
Units
mA
mA
µA
µA
VosOO
VosII
No Signal, VCM=0
-5 — +5
-5 — +5
mV
-250 — +250 -250 — +250
µV
G=voltage gain -5-0.25G 5+0.25G -5-0.25G 5+0.25G mV
VIN-CM
VIN-UNBAL
Common mode, all gains — ± 13 —
Unbalanced
-13 — +13
One input to GND, 0dB gain
Gdiff
0 — 70
— ±8 —
— 10 —
—0—
ZIN-DIFF
ZIN-CM
Differential
0dB gain
20dB gain
40dB gain
60dB gain
Common mode
all gains
— 32||1.9 —
— 32||2.0 —
— 32||2.5 —
— 29||8.0 —
— 8||7.7 —
— ± 13 —
V
-13 — +13
V
-6 — 64
dB
— ±8 —
V
— 15 —
kΩ
—0—
dB
— 37||1.9 —
— 37||2.0 —
— 36||3.1 —
— 31||13.9 —
— 9||7.7 —
MΩ||pF
MΩ||pF
MΩ||pF
MΩ||pF
MΩ||pF
1. All specifications are subject to change without notice.
2. Unless otherwise noted, TA=25ºC, VCC=+15V, VEE= -15V.
3. Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only; the functional operation of
the device at these or any other conditions above those indicated in the operational sections of this specification is not impli ed. Exposure to absolute maximum rating
conditions for extended periods may affect device reliability.
THAT Corporation; 45 Sumner Street; Milford, MA 01757-1656; USA
Tel: [phone]; Fax: [phone]; Web: www.thatcorp.com
Copyright © 2013, THAT Corporation