SM5106 Datasheet, PDF (2/2 Pages) List of Unclassifed Manufacturers – Small, Low Cost OEM Pressure Die

SM5106
CHARACTERISTICS FOR SM5106 - SPECIFICATIONS
All parameters are measured at 5.000V supply at room temperature, unless otherwise specified.
Min.
Typ.
Max.
Units
Notes
Excitation Voltage
Excitation Current
Span (FS Range)
15 PSI
30 PSI
60 PSI
150 PSI
Offset
TC Span
TC Offset
TC Resistance
Linearity
Bridge Impedance
Proof Pressure
Burst Pressure
Operating Temperature
Storage Temperature
0
0
75
85
85
100
-35
-24
-7
+24
-0.45
4
3X
5X
-40
-55
5.0
1.5
100
110
125
145
8
-19
-1
+27.5
-0.15
5
15
V
1
2.5
mA
1
2
125
mV
130
mV
150
mV
195
mV
35
mV
-15.5
%FS/100°C
3
+7
%FS/100°C
3
+33
%/100°C
3
+0.45
%FS
4
6
kΩ
Rated FS
Rated FS
+125
°C
+150
°C
Notes:
1. Bridge may be driven with positive or negative excitation; positive output for positive pressure applied to circuit side of die
when bridge is driven with positive voltage.
2. Measured at 5V constant voltage excitation.
3. Measured from 0 to 70 C
4. Defined as best straight line.
+Vexc
0.30 mm
1.56
mm
Sig+
Vsub
0.13 mm
ORDERING INFORMATION:
Model Number
SM5106 - 015 - A
A: Absolute (only)
Pressure
range
Pressure
Type
Pressure Ranges
PSI 5106
15 015
30 030
60 060
150 150
Sig-
0.40
mm
0.20 mm
0.05
mm
0.20 mm
-Vexc
1.56 mm
SM5106 (1.56 mm square as sawn)
Covered under USA Mask-Copyright
See separate Application Notes for typical range of variation in Saw
dimensions.
Notice:
Silicon Microstructures, Inc. reserves the right to make changes to the product contained in this publication. Silicon Microstructures, Inc. assumes no responsibility for the use of any
circuits described herein, conveys no license under any patent or other right, and makes no representation that the circuits are free of patent infringement. While the information in this
publication has been checked, no responsibility, however, is assumed for inaccuracies.
Silicon Microstructures, Inc. does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reasonably be expected to
cause failure of a life-support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications.
Rev 1.2 8_02
 2001-2002
Silicon Microstructures, Inc. ♦ 1701 McCarthy Blvd. ♦ Milpitas, CA 95035 USA
Tel: [phone] ♦ Fax: [phone] ♦ [e-mail] ♦ WWW.Si-Micro.Com