OP227GN Datasheet, PDF (2/9 Pages) List of Unclassifed Manufacturers – MICROCIRCUIT, LINEAR, LOW NOISE OPERATIONAL AMPLIFIER, MONOLITHIC SILICON

1. SCOPE
1.1 Scope. This drawing describes device requirements for MIL-STD-883 compliant, non-JAN class level B microcircuits in
accordance with MIL-PRF-38535, appendix A.
1.2 Part or Identifying Number (PIN). The complete PIN is as shown in the following example:
5962-86887
01
C
A
Drawing number
Device type
(see 1.2.1)
Case outline
(see 1.2.2)
Lead finish
(see 1.2.3)
1.2.1 Device type(s). The device type(s) identify the circuit function as follows:
Device type
Generic number
Circuit function
01
OP-227A
Dual, low-offset, low noise operational amplifier
1.2.2 Case outline(s). The case outline(s) are as designated in MIL-STD-1835 and as follows:
Outline letter
Descriptive designator
Terminals
Package style
C
GDIP1-T14 or CDIP2-T14
14
Dual-in-line
1.2.3 Lead finish. The lead finish is as specified in MIL-PRF-38535, appendix A.
1.3 Absolute maximum ratings. 1/
Supply voltage (V_CC) ............................................................. ±22 V dc
Input voltage range (V_IN) ........................................................ ±22 V dc
Output short circuit duration .................................................... Indefinite
Differential input current .......................................................... ±25 mA 2/
Differential input voltage range ............................................... ±0.7 V dc
Lead temperature (soldering, 60 seconds) ............................. +300°C
Storage temperature range ..................................................... -65°C to +150°C
Maximum power dissipation (P_D) ........................................... 500 mW 3/
Thermal resistance, junction-to-case (θ_JC) ............................. See MIL-STD-1835
1.4 Recommended operating conditions.
Supply voltage (V_CC) ............................................................. ±4.5 V dc to ±18 V dc
Ambient operating temperature range (T_A) ............................. -55°C to +125°C
______
1/ Unless otherwise specified, all voltages are references to ground.
2/ The inputs are protected by back-to-back diodes. Current limiting resistors are not used in order to achieve low noise.
If differential input voltage exceeds ±0.7 V, the input current should be limited to 25 mA.
3/ For T_A greater than 106°C, derate linearly at 11.3 mW/°C.
STANDARD
MICROCIRCUIT DRAWING
DLA LAND AND MARITIME
COLUMBUS, OHIO 43218-3990
DSCC FORM 2234
APR 97
SIZE
A
REVISION LEVEL
C
5962-86887
SHEET
2