E3199LF Datasheet, PDF (2/2 Pages) List of Unclassifed Manufacturers – Oscillator Specification

Oscillator Specification: E3199 / E3199LF
HOLDOVER STABILITY [(Fmax-Fmin) /2.Fo]
Temperature, -40 to 85^oC
ditto, inclusive of
Supply Voltage, 3.3V ± 5% and
Ageing, 24 hours
 ± 0.28 ppm
 ± 0.32 ppm
FREE-RUN ACCURACY, incl.
Calibration @ 25 ^oC,
Temperature, -40°C to 85^oC,
Supply Voltage, 3.3V ± 5%,
Load, 15pF±5%
Reflow soldering and
Ageing, 20 years
 ± 4.6 ppm ref. to Fo
Phase Noise:
10 Hz
100 Hz
1 kHz
10 kHz
 -85 dBc/Hz
 -110 dBc/Hz
 -125 dBc/Hz
 -130 dBc/Hz
Tri-State
Pad 8 open circuit or  0.6Vs
Output Enabled
Pad 8  0.2Vs
Output Tri-stated
When in tri-state mode, the output stage is disabled but the oscillator and compensation circuit
are still active (Current consumption ≈ 1mA).
Environmental:
Storage Temperature Range: -55 to +125C
Vibration: IEC 60068-2-6 Test Fc Procedure B4, 10-60Hz 1.5mm displacement, at 98.1 ms^-2,
Shock:
30 minutes in each of three mutually perpendicular axes at 1 octave per minute
IEC 60068-2-27 Test Ea, 980ms^-2 acceleration for 6ms duration, 3 shocks in each
direction along three mutually perpendicular axes
Soldering: SMD product suitable for Convection Reflow soldering.
Peak temperature 260°C. Maximum time above 220°C, 60 secs.
Solderability: MIL-STD-202, Method 208, Category 3
Marking: Laser Marked
RoHS
Parts with the “LF” suffix are fully compliant with the European Union directive
2002/95/EC on the restriction of the use of certain hazardous substances in electrical
and electronic equipment. Note these RoHS compliant parts are suitable for assembly
using both Lead-free solders and Tin/Lead solders.
Page 2 of 2