D90910210024 Datasheet, PDF (2/3 Pages) List of Unclassifed Manufacturers – Modem Interface

D 9091 0210
Du line^®
Fieldbus Installationbus
General Specifications
Additional Information
Power ON delay
≤2s
Indication for
Supply ON (PWR)
LED, green
Call initiate (CI)
LED, green
External Dupline OK (EXD) LED, yellow
Modem connection OK (CON) LED, yellow
Environment
Degree of protection
Pollution degree
Operating temperature
Storage temperature
IP 20
3 (IEC 60664)
0° to +50°C (+32° to +122°F)
-50° to +85°C (-58° to +185°F)
Humidity (non-condensing) 0 to 80%
Mechanical resistance
Shock
Vibration
15 G (11 ms)
2 G (6-55 Hz)
Material
Light grey polystyrol
Weight
600 g
Scope of supply
1 x Modem Interface
1 x Power cable, 2 m
1 x User manual
Dimensions (mm)
D 9091 210...
PWR 230
MAN D90xx ENG
Mode of Operation
D 9091 0210 is a Dupline^®
modem interface for easy
control of Dupline^® networks
through the telephone lines.
Configuration of the interface
is done by means of the con-
figurator type D 9080 or by
means of a personal compu-
ter running the terminal emu-
lator software D 9091 SW01.
The modem interface features
3 main functions for which it
can be configured: public line
mode, private line mode and
RS 232 interface.
For status indication 4 LEDs
are used:
• Call initiate (CI): to identify
the dialling modem.
• External Dupline^® OK (EXD):
indicating that the connect-
ed Dupline^® is working pro-
perly.
• Modem connection OK
(CON): showing that con-
nection is established be-
tween the 2 modems.
• Power supply ON (PWR): to
indicate that power is appli-
ed to the unit.
The Run/program push but-
ton (5) (accessible with a pen
through a hole on the right
side of the housing) is used to
switch the interface to confi-
guration or Run-mode. When
this push button is held down
for 5 s the interface changes
mode. Configuration mode is
indicated by flashing of the
three LEDs - CI, EXD and
CON.
The voltage selector switch (6)
(only on D 9091 0210 230) is
used to adapt the unit to the
supply voltage.
Note: The D 9091 0210 230 is
factory set for 230 VAC.
To change the supply voltage
proceed as follows:
1. disconnect the power
2. remove the 4 housing
screws at the bottom of the
unit.
3. lift off the housing top cover
4. move switch (6) into po-
sition for selected voltage
5. reassemble the unit
6. change supply voltage label
on the rear of the housing
7. connect power cable to
power connector (7).
The relay output (8) deener-
gizes whenever one of the fol-
lowing problems is detected:
• Transmission breakdown
• Continuous reception of
corrupted data
• External Dupline^® off-line
• Reception of an alarm call
The Dupline^® transmission
inhibit input (10) is used to
reset the data buffer and igno-
re the data received from the
counterpart station. For more
details, refer to the description
in the manual.
2
Specifications are subject to change without notice (28.09.99)
Dupline^® is a registered trademark. A product of the CARLO GAVAZZI Group