AU9223 Datasheet, PDF (18/21 Pages) List of Unclassifed Manufacturers – USB KVM Controller Technical Reference Manual

6.6 Latch-Up Test Results
Test Description: Latch-Up testing was performed at room ambient using an
IMCS-4600 system which applies a stepped voltage to one pin per device with all
other pins open except Vdd and Vss which were biased to 5 Volts and ground
respectively.
Testing was started at 5.0 V (Positive) or 0 V(Negative), and the DUT was biased for
0.5 seconds.
If neither the PUT current supply nor the device current supply reached the
predefined limit (DUT=0 mA , Icc=100 mA), then the voltage was increased by 0.1
Volts and the pin was tested again.
This procedure was recommended by the JEDEC JC-40.2 CMOS Logic
standardization committee.
Notes:
1. DUT: Device Under Test.
2. PUT: Pin Under Test.
Figure 6.2 Latch-Up Test Results
Icc Measurement
m
1 Source
Untested
Input Tied
to V supply
+
Trigger
Source
Piinn ^Vcc
u^unn^dd^ee^rr
t^tee^ss^tt _DUT
GND
V Supply
+
Untested
Output Open
Circuit
Test Circuit : Positive Input/ output Overvoltage /Overcurrent
AU9223 USB KVM Controller V1.00
Official Release_ Public
Page 18 of 21