103643 Datasheet, PDF (17/24 Pages) List of Unclassifed Manufacturers – Bus Interface Connector System

ERbic SafetyBUS p
The SafetyBus p utilizes the advantages of the CAN bus. A
protocol has been developed by Pilz that satisfies safety engi-
neering requirements.
A larger cable cross section of 0.75 mm2 is specified to
cover longer distances. Only the 3 conductors necessary for
the bus are terminated within the connector (HLG).
Electrical and mechanical characteristics
Interface connector
D-Sub female
Cable termination

Cable diameter
Cross section of individual conductor
Termination type
Data transmission rate
Temperature range
Permissible humidity
Protection class
Housing material
D-Sub screw
UL approval
CE marking


D-Sub, 9-pin, female
Class 2
2 x horizontal
1 cable outlet can be sealed with blanking plate
4.5 mm (0.177”) – 8.0 mm (0.315”)
Max. 1.5 mm²
Screw terminal
According to CAN specification, max. 1 Mbit/s
-20 °C – +70 °C
Max. 75 % at +25 °C, non-condensing
IP 40
Thermoplast UL94V-1
#4/40 UNC, knurled with cross-head
UL E84703 *
ERbic connectors are passive components and do not need
to be identified with the CE marking according to EU direc-
tives.
* Due to continuous advancement, it is possible that the UL approval of a new version may not have been completed at the time of going
to press.
Pin configuration (HLG-Version)
Terminal
1
2
3
-
D-Sub Pin
3
2
7
5
Signal
CAN-GND
CAN-L
CAN-H
CAN-SHLD
Catalog E 074441 01/06
Edition 4
www.erni.com
17