|
NANO100NC2BN Datasheet, PDF (14/160 Pages) List of Unclassifed Manufacturers – 32-bit Microcontroller | |||
|
◁ |
NUMICRO® NANO100 (B) DATASHEET
ïµ 12-bit SAR ADC up to 2Msps conversion rate
ïµ Up to 12-ch single-ended input from external pin (PA.0 ~ PA.7 and PD.0 ~ PD.3)
ïµ Six internal channels from DAC0, DAC1, internal reference voltage (Int_VREF),
Temperature sensor, AVDD, and AVSS.
ïµ Supports three reference voltage sources from VREF pin, internal reference
voltage (Int_VREF), and AVDD.
ïµ Supports Single Scan, Single Cycle Scan, and Continuous Scan mode
ïµ Each channel with individual result register
ïµ Only scan on enabled channels
ïµ Threshold voltage detection (comparator function)
ïµ Conversion started by software programming or external input
ïµ Supports PDMA mode
ïµ Supports up to four timer time-out events (TMR0, TMR1, TMR2 and TMR3) to
enable ADC
ï¬ DAC
ïµ 12-bit monotonic output with 400K conversion rate
ïµ Supports three reference voltage sources from VREF pin, internal reference
voltage (Int_VREF), and AVDD.
ïµ Synchronized update capability for two DACs (group function)
ïµ Supports up to four timer time-out events (TMR0, TMR1, TMR2 and TMR3),
software or PDMA to trigger DAC to conversion
ï¬ SmartCard (SC)
ïµ Compliant to ISO-7816-3 T=0, T=1
ïµ Supports up to three ISO-7816-3 ports
ïµ Separates receive/transmit 4 bytes entry FIFO for data payloads
ïµ Programmable transmission clock frequency
ïµ Programmable receiver buffer trigger level
ïµ Programmable guard time selection (11 ETU ~ 266 ETU)
ïµ A 24-bit and two 8-bit time-out counters for Answer to Reset (ATR) and waiting
times processing
ïµ Supports auto inverse convention function
ïµ Supports stop clock level and clock stop (clock keep) function
ïµ Supports transmitter and receiver error retry and error limit function
ïµ Supports hardware activation sequence process
ïµ Supports hardware warm reset sequence process
ïµ Supports hardware deactivation sequence process
ïµ Supports hardware auto deactivation sequence when detect the card is removal
ïµ Supports UART mode (Half Duplex)
ï¬ EBI (External bus interface) support
May 31, 2016
Page 14 of 160
Revision 1.08
|
▷ |