RFM02 Datasheet, PDF (12/24 Pages) List of Unclassifed Manufacturers – Universal ISM Band FSK Transmitter

Oscillator control logic
RFM02
3. Frequency Setting Command
bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0 POR
1 0 1 0 f11 f10 f9 f8 f7 f6 f5 f4 f3 f2 f1 f0 A7D0h
The 12-bit parameter of the Frequency Setting Command <f11 : f0> has the value F. The value F should
be in the range of 96 and 3903. When F is out of range, the previous value is kept. The synthesizer
center frequency f0 can be calculated as:
f0 = 10 MHz * C1 * (C2 + F/4000)
The constants C1 and C2 are determined by the selected band as:
Band [MHz] C1
C2
433
1
43
868
2
43
915
3
30
Note:
• For correct operation of the frequency synthesizer, the frequency and band of operation need to be
programmed before the synthesizer is started. Directly after activation of the synthesizer, the RF VCO is
calibrated to ensure proper operation in the programmed frequency band.
4. Data Rate Command
bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0 POR
1 1 0 0 1 0 0 0 r7 r6 r5 r4 r3 r2 r1 r0 C800h
The transmitted bit rate is determined by the 8-bit value R (bits <r7 : r0>) as:
BR = 10 MHz / 29 / (R+1)
Apart from setting custom values, the standard bit rates from 2.4 to 115.2 kbps can be approximated with
minimal error.
Note:
• PLL bandwidth should be set according the data rate. Please see the PLL Setting Command.
Tel: [phone] Fax: [phone] E-mail: [e-mail] http://www.hoperf.com