TC-1100RVN3 Datasheet, PDF (10/17 Pages) List of Unclassifed Manufacturers – 1100W Redundant Power Supply

3.9 Hot-swap procedures
Please refer to the following when either power module or the fan found
defective.
A) Locate the defective power module by examining the individual LED (if LED
without light, it indicates the power module is defective).
WARNING:
Please perform the above step carefully otherwise it may cause shut down the
whole system.
WARNING:
Please do not remove the defective power module until you have worn gloves to
keep from be burned. This is due to the cover of the power module is used as heat
sink for cooling, usually the temperature is around 50 ~ 60 degree Celsius under
full load condition.
B) Loosen the bracket screws of the power module
C) Remove the defective power module by pulling out method
WARNING:
Please put aside the power module await for cooling down. Keep from other
people tough it until it is cool.
D) Replace a new Good power module, insert the power module into the power
system to the end.
E) Check the LED of the power module light Green.
F) Check the LED indicating the total power system status. It should be from
twinkle to Green.
G) Tighten the screws of the power module to fix it.
⑩