VLED-50W Datasheet, PDF (1/4 Pages) List of Unclassifed Manufacturers – Dimmable LED Drivers

VLED-50W Series
Dimmable LED Drivers
Constant Current
Aluminum Housing
Electrical Specifications
Input Voltage Range:
100 - 277 Nom. Vac (90 - 305 V Min/Max)
Frequency:
50/60 Hz Nom. (47-63 Hz Min/Max)
Power Factor:
>0.90 @ full load, 100V through 277V
Inrush Current:
60 A @ 220Vac
Input Current:
0.80 A @ 100 Vac, 0.40 A @ 220 Vac
Maximum Power:
50W
Line Regulation:
± 1%
Load Regulation:
± 3%
Leakage Current:
0.75 mA max @ 277Vac 60Hz
THD:
<_ 20% @ 100-277Vac, 75-100% load
Turn-on Delay:
0.6S @ 110Vac, 0.3S @ 220Vac Typical
Protection:
Over-Voltage, Over-Temperature (Hiccup Mode),
Over-Load, Short Circuit Protection with Self-Recovery
Environmental Specifications
Minimum Starting Temp: -40ºC
Maximum Case Temp. 90°C
Storage Temperature:
-40ºC to +85ºC
Humidity:
10% to 100%
Cooling:
Convection
Sound Rating:
Class A
MTBF:
321,000 Hours @ 25ºC, 80% load, 120Vac input
(MIL-HDBK-217F)
Lifetime:
93,300 Hours @ 60ºC case temperature, 80% load,
120Vac input
Weight:
480 g
• Total Power: 52 Watts
• Input Voltage: 100-277 Vac Nom.
• UL Dry & Damp Location Rated
• IP67
• High Efficiency & High Power Factor
• Output Protection & Lightning Protection
• UL8750 and EN61347 Certified
Ordering Options:
-D: 0-10V dimmable version comes with an extra three wires +Purple/-Gray/Yellow on
the output side. 0-10V Dimming is compatible with most quality 0-10V wall dimmers
and direct 0-10V analog signal. See page 2 for additional specifications.
Constant Current - Product Specifications
Model Number
Output Current Output Voltage Max. Output Typical
(mA ±5%)
Range (Vdc) Power (W) Efficiency
VLED50W-149-C0350-XX
VLED50W-116-C0450-XX
VLED50W-075-C0700-XX
VLED50W-050-C1050-XX
VLED50W-037-C1400-XX
VLED50W-025-C2100-XX
350
450
700
1050
1400
2100
75-149
58-116
38-75
25-50
19-37
13-25
52
90%
52
89%
52
89%
52
88%
52
87%
52
86%
-XX indicates dimming options are available. See options at left. Blank = fixed current output
Class 2: US/Canada US Only
E332160
Note:
LED drivers are designed and intended to operate LED loads only.
Non-LED loading may be outside the specified design limits of our
LED drivers, and therefore cannot be covered by any warranty.
If you desire to use our LED drivers to operate non-LED loads
please contact us to discuss compatibility.
Specifications subject to change without notice.
UL/CUL
CE
FCC Part 15
EN55015
EN61000-3-2
EN61000-3-3
EN61000-4-2
EN61000-4-3
EN61000-4-4
EN61000-4-5
EN61000-4-6
EN61000-4-8
EN61000-4-11
EN61547
Safety and EMC Compliance
UL8750, UL1012, UL1310 Class 2,
CSA-C22.2 No. 107.1, CSA-C22.2 NO. 223-M91 Class 2
EN61347-1, EN61347-2-13
ANSI C63.4: 2009 Class B
Conducted emission Test & Radiated emission Test
Harmonic current emissions
Voltage fluctuations & flicker
Electrostatic Discharge (ESD):
4kV contact discharge, 8kV air discharge
Radio-Frequency Electromagnetic Field Susceptibility Test-RS
Electrical Fast Transient / Burst-EFT: Level 3, Criteria A
Surge Immunity Test: AC Power Line:
line to line 4 kV, line to earth 6 kV
Conducted Radio Frequency Disturbances Test-CS
Power Frequency Magnetic Field Test
Voltage Dips
Electromagnetic Immunity Requirements
Applies To Lighting Equipment
Rev 8-25-15
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com