TWR-PI Datasheet, PDF (1/1 Pages) List of Unclassifed Manufacturers – ZenNet Wireless Lighting On/Off Plug-in Switch Module

TWR-PI Plug-in Wireless Relay
ZenNet Wireless Lighting On/Off Plug-in Switch Module
5 year Warranty
Specifications
Power Supply
120Vac, 50/60Hz
Maximum Load
• General Purpose – 15A @ 120Vac
• Resistive – 15A @ 120Vac
• Tungsten – 960W @ 120Vac
• Ballast – 600W @ 120Vac
• Motor Load Rating – ½ HP @ 120Vac
Power Consumption
Inputs/Outputs
1.1W @ full load, 500mW quiescent
• Standard male plug for power input
• Standard female plug for controlled output
• 1 normally open relay
• Input for accessory tabletop rocker pad
• Radio Frequency (RF) transceiver
• 2 Buttons with LEDs -- configuration & manual control
RF Communications
Transmission Range
Dimensions
Weight
Cord Lengths
Mounting
Environment
EnOcean 902 MHz
80ft (25m)
4.09”H x 1.85”W x 1.26”D (103.9mm x 47mm x 32mm)
12.3oz. (348g
Plug cord: 3ft. (91.4cm)
Outlet cord: 1 ft. (30.5cm)
Free standing, or mounts to wall using
included mounting plate
• Indoor use only
• 32° to 131° F (0° to 55° C)
• 20% to 95% relative humidity (non-condensing)
Interoperable Products
(EnOcean Profiles)
• Rocker Pad Switch (F6-02-02)
• Key Card Switch (F6-04-01)
• Window handle (F6-10-00)
• 1BS Single Input Contact (D5-00-01)
• Temperature Sensor, 0° to 40° C (A5-02-05)
• Occupancy Sensor (A5-07-01)
• Contact, single input (A5-30-01)
• Central Gateway (A5-38-08)
ZenNet Wireless Lighting Controls
Part Number
Description
TWR-PI-W
White 2 button Fixture Control Module
ZenNet Plug-In Relay Module provides simple wireless solution for
lighting control through any standard outlet. The module uses ultra
low power radio frequency technology to communicate wirelessly.
Simply plug the module into any standard outlet and then plug the
lamp into the receptacle on the opposite end. Link the module to a
ZenNet switch or occupancy sensor for convenient wireless control.
• Provides switching of plug-in electrical loads
• Plugs into any standard outlet, no wiring required
• Two molded buttons with LED indicator lights can be used to
configure or manually control the device.
• Easily links with wireless rocker pads or sensors
Dimensions (Nom.)
1.85”
47mm
4.09”
104mm
1.18”
30mm
Set (I) Button
Menu (O) Button
UL/CUL
CSA
FCC
IC
Agency Compliance
UL244A, UL1472
22.2 No. 184
SZV-STM300U
5713A-STM300U
1’ Cord to
Receptacle End
3’ Cord to Plug End
Specifications subject to change without notice.
Rev 7-8-15
Thomas Research Products • 1215 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com