TWR-D10 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – ZenNet Wireless LED Lighting Dimmable In-line Relay Module

TWR-D10 Dimming Relay Module
ZenNet Wireless LED Lighting Dimmable In-line Relay Module
5 year Warranty
Specifications
Power Supply
120/277Vac, 50/60Hz
Maximum Load
• General Purpose – 16A @ 120/277Vac
• Resistive – 16A @ 120/277Vac
• Tungsten – 960W @ 120Vac
• Ballast – 600W @ 120Vac (eg, 20 30W ballasts)
Power Consumption
0-10V Output
Surge Protection
Inputs/Outputs
1.1W @ full load, 500mW quiescent
Current sinking 20mA / sourcing 5mA
Exceeds IEC61000-4-5 installation class 4
• Flying-lead style power input wires
• 1 normally open relay
• 1 switched output wire
• 2 output wires for 0-10V dimmer control
• Radio Frequency (RF) transceiver
• 2 Buttons/1 LED for configuration & manual control
RF Communications
Transmission Range
Dimensions
Weight
Mounting
Environment
EnOcean 902 MHz
80ft (25m)
2.78”H x 1.65”W x 1.1”D (73mm x 42mm x 28mm)
3.2 oz (90.72g)
• Install inside standard electrical box
• 1/2” threaded nipple
• Indoor use only
• 32° to 140° F (0° to 60° C)
• 20% to 95% relative humidity (non-condensing)
EnOcean Profile
Interoperable Products
(EnOcean Profiles)
A5-11-01
• Rocker Pad Switch (F6-02-02)
• Occupancy Sensor (A5-07-01)
• Occupancy Sensor (A5-07-02)
• Occupancy Sensor (A5-07-03)
• Light Sensor (A5-06-02)
• Light Sensor (A5-06-03)
• Demand Response (A5-37-01)
• Central Gateway Controller (A5-38-08)
ZenNet Wireless Lighting Controls
Part Number
Description
TWR-D10
White Wireless Relay with 0-10V Dimming, threaded nipple
ZenNet Wireless LED Dimming Control Module uses radio frequency
technology to communicate with ZenNet self-powered input devices,
providing a simple stand-alone solution for lighting control.
The compact module is easily wired out of sight.
• Enables wireless dimming of LED luminaires using 0-10V control
• Supports manual dimming or daylight harvesting scenarios
with occupancy control, using input from self-powered switches
and sensors
• Wireless software commissioning with available software
• Implements load shedding initiated by demand response controllers
• Two molded buttons with LED indicator can be used to configure
or manually control the device
• Installs inside or mounts to electrical box using threaded connector
• Includes surge protection
• Also connects to central gateway controllers, for use with
building automation systems such as BACnet
• ½” Tradesize Nipple (For ⅞” Diameter Hole)
UL/CUL
CSA
FCC
IC
Agency Compliance
UL244A, UL1472
22.2 No. 184
SZV-STM300U
5713A-STM300U
Specifications subject to change without notice.
Rev 7-7-15
Thomas Research Products • 1215 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com