TWO-WL Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – ZenNet Self-powered Wireless Wall-mount Sensor

TWO-WL-W Occupancy Sensor
ZenNet Self-powered Wireless Wall-mount Sensor
5 year Warranty
Specifications
Power Supply
Indoor light energy harvesting
(Optional supplemental battery or 2-wire connector
for external power or remote solar cell)
RF Communications
EnOcean 902 MHz
Transmission Range
80ft (25m)
Motion Detection Range 50ft. (15m) wide angle lens, 100ft. (30m) long range lens
Minimum Operating Light 50 lux (for auto-off only)
Dimensions
5.83” H x 2.52” W x 1.8” D (148mm x 64mm x 45mm)
Mounting Height
6-8 feet (1.8-2.5m) recommended
Startup Charge Times
(from empty)
Linking = 4 min @ 100 lux,
1.5 min @200 lux
Motion Transmission = 6 min @ 100 lux,
3.5 min @ 200 lux
Note: Bright light or battery can be temporarily used
to shorten initial startup charge times
Charge Time to Full
25 hrs @ 200 lux
Sustaining Charge Time 3 hours per 24 hours @ 200 lux
Motion Transmission
Interval
60 - 300 seconds (based on real-time charge rate)
60 sec @ 200 lux - 300 sec @ 50 lux
Heartbeat Transmission 120 - 600 seconds (based on real-time charge rate)
Interval
120 sec @ 200 lux - 600 sec @ 50 lux
Operating Life
in Darkness
EnOcean Profile
48 hours (after full charge)
A05-07-02
ZenNet Wireless Lighting Controls
Part Number
Description
TWO-WL-W
White solar cell wall-mount occupancy sensor
ZenNet self-powered wall-mounted Occupancy Sensor uses ultra
low power radio frequency technology to communicate wirelessly
for turning off lights and electrical loads when a space has been
unoccupied for a set period of time.
The sensor harvests solar energy from indoor light, eliminating the
need for periodic battery changes. No additional wiring is needed,
and installation can be completed in a matter of minutes. On-going
maintenance costs are eliminated.
ZenNet sensor enables a new level of energy saving for rooms,
hallways and other common areas. Unit features clean contemporary
styling.
• Harvests indoor light to power the sensor
• Sends messages to other devices when motion is detected
• PIR motion sensor (Interchangeable lenses for tailored coverage)
• Built-in tests to confirm operation
• Two buttons with LED indicator lights configuring the device
• Alternate power supply options for extreme low light conditions
• Mounts flush on ceiling or in a corner
Agency Compliance
FCC
SZV-EOSC05
IC
5713-EOSC05
Specifications subject to change without notice.
Rev 7-8-15
Thomas Research Products • 1215 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com