TRV-075 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – Switch Mode LED Drivers

75W TRV-075 Series
Switch Mode LED Drivers
Constant Voltage
Aluminum Housing
Electrical Specifications
Input Voltage Range:
100 - 277 Nom. Vac (90 - 305 V Min/Max)
Frequency:
50/60 Hz Nom. (47-63 Hz Min/Max)
Power Factor:
0.85 min @ 100V through 277V, 75-100% load
Input Current:
0.88 A max 100Vac
Maximum Power:
75W
Line Regulation:
± 1%
Load Regulation:
± 2%
Turn-on Delay:
Protection:
1.2S max @ 120V
Over-Voltage, Over-Current, Over-Temperature (110°C),
and Short Circuit Protection with Auto Recovery
Environmental Specifications
Minimum Starting Temp: -35ºC
Maximum Case Temp: 88°C
Minimum Starting Temp: -35ºC
Storage Temperature:
-40ºC to +85ºC
Humidity:
5% to 100%
Cooling:
Convection
Sound Rating:
Class A
Vibration Frequency:
5 to 55 Hz/2g, 30 minutes
MTBF:
350,000 Hours @ full load and 25ºC ambient conditions
per MIL-HDBK-217F
Lifetime:
83,000 Hours @ 220V, 80% load, 25ºC ambient
• Total Power: 75 Watts
• Input Voltage: 100-277 Vac Nom.
• UL Dry & Damp Location Rated
• IP67
• Ultra-high Efficiency
• High Power Factor
• UL8750
New Surge Protection and HI-POT Testing
Metal Lock Sheet
Nut
Model Number
TRV-075S012ST
TRV-075S024ST
TRV-075S036ST
TRV-075S042ST
TRV-075S048ST
TRV-075S054ST
Output Current Output Voltage
Range (A)
(Vdc)
0-6.25
12
0-3.13
24
0-2.08
36
0-1.79
42
0-1.56
48
0-1.39
54
Max. Output
Power (W)
75
75
75
75
75
75
Typical
Efficiency
90%
92%
92%
92%
92%
92%
HI-POT Test
Normal Application
The new design of this LED driver provides 1.4KV surge protection. To properly
HI-POT test this unit, the surge protection must be disconnected. The screw, nut, and
metal lock sheet on the input side of the driver provide for this. To test, first remove
the nut and lock sheet as shown. After testing, secure the nut and lock sheet to
provide line-to-earth protection.
This HI-POT test feature is available on product manufactured after August 15, 2015.
E332160
Note:
LED drivers are designed and intended to operate LED loads only.
Non-LED loading may be outside the specified design limits of our
LED drivers, and therefore cannot be covered by any warranty.
If you desire to use our LED drivers to operate non-LED loads
please contact us to discuss compatibility.
Specifications subject to change without notice.
Rev 8-27-15
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com