TC-1U35 Datasheet, PDF (1/5 Pages) List of Unclassifed Manufacturers – OVER-VOLTAGE PROTECTION

SURE STAR COMPUTER CO., LTD
NO.2-1,DAAN ROAD, SHULIN .DIST., NEW TAIPEI CITY 238 , TAIWAN.
E-mail: [e-mail]
Tel: [phone]
http: //www.surestar.com.tw
Fax: [phone]
MODEL:TC-1U35 (350W for 1U Single)
1. Specification
1.1 AC Input Voltage: 90 to 132 or 180 to 264 Auto selectable 50 to 60 Hz.
1.2 DC Output: 350W maximum
Output-1 Output-2 Output-3 Output-4 Output-5
Voltage:
+5V DC +12V DC -5V DC -12V DC +3.3V DC
Maximum Load:
35A
18A
0.3A
0.8A
20A
Minimum Load:
3A
2A
0.1A
0.1A
0.3A
Ripple:
50mv 120mv 50mv 120mv 50mv
Ripple/Noise:
100mv 150mv 100mv 240mv 50mv
Line Regulation:
±1﹪
±1﹪
±1﹪
±1﹪
±1﹪
Output Regulation:
±5﹪
±5﹪
±10﹪ ±10﹪
±5﹪
Cross Regulation:
±5﹪
±5﹪
±10﹪ ±10﹪
±5﹪
Note:
1. Noise Test – Noise bandwidth is from DC to 20 MHz.
2. Ripple frequencies greater than 1MHz shall be attenuated by the
measurement
System.
3. Add 0.1uF/10uF capacitor at output connector terminals for ripple and noise
measurements.
4. The combined total power from 5V & 3.3V shall not exceed 175W.
The combined total power from 5V and 12V & 3.3V shall not exceed 328W
5. +5V SB DC Output 2A.
1.3 PS-ON
Remote On/Off Control:
When PS-ON is pulled to TTL Low, the DC output is to be enabled.
When PS-OFF is pulled to TTL high, the DC output is to be disabled.
1.4 PW-OK
PW-OK is power good signal and should be asserted high by the power
supply to indicate that +5VDC and +3.3VDC output are above the under
voltage thresholds of the power supply TTL. compatible signal out with
100ms to 500ms.
①