TANGO-16 Datasheet, PDF (1/4 Pages) List of Unclassifed Manufacturers – GPS antenna combined

Tango 16
Vandal Resistant Body Mount GPS/GSM Combo Antenna
Key Features
• 2dBi GSM gain, 28 ± 2 dBi gain
• Quadband GSM, 3G and ISM compatible
• GPS antenna combined
• IP67 rated
• Rugged and durable
• Through hole mount
• O ring seal - prevents water ingress
• RoHS compliant
General Description
The TANGO16 is an IP67 rated and fully weatherproof
combination GSM/GPS antenna intended for outdoor
equipment such as vending machines and similar. The
TANGO16 has a GSM gain of 2dBi, the GPS antenna has
an LNA gain of 28dB and a V.S.W.R of <2.0.
The TANGO16 mounts via an M12 stud and is 50mm
diameter at its base and 48mm tall. The circular rubber O
ring on the bottom face is to ensure that water does not
seep through the bolt hole when secured to the equipment
using the antenna.
The TANGO16 is a robust and well-made antenna that has
a great performance and will last for years in an outdoor
environment.
Moisture Proof
The device should satisfy the electrical characteristics
specified in the table ‘Key Specifications - Dieletric
Anntena’ after exposed to the temperature 40±2°C and
the relative humidity 90~95% RH for 96 hours and 1~2
hours recovery time under normal condition.
Vibration Resist
The device should satisfy the electrical characteristics
specified in the table ‘Key Specifications - Dieletric
Antenna’ after applied tot the vibration of 10 to 55MHz
with amplitude of 1.5mm for 2 hours each in X, Y, and Z
directions.
A member of the Olancha Group Ltd
Registered in England No. 08405712
VAT Registration No. GB163 04 0349
Drop Shock
The device should satisfy the electrical characteristics
specified in the table ‘Key Specifications - Dieletric
Antenna’ after dropping onto the hard wooden board
from the height of 30cm for 3 times each facet of the 3
dimensions of the device.
High Temperature Endurance
The device should satisfy the electrical characteristics
specified in the table ‘Key Specifications - Dieletric
Antenna’ after exposed to the temperature 80±5°C for
24±2 hours and 1~2 hours recovery time under normal
temperature.
Low Temperature Endurance
The device should satisfy the electrical characteristics
specified in the table ‘Key Specifications - Dieletric
Antenna’ after ex[psed to the temperature -40±5°C for
24±2 hours and 2 hours recpveru time under normal
temperature.
Temperature Cycle Test
The device should atisfy the electrical characteristics
specified in the table ‘Key Specifications - Dielectric
Antenna’ after exposed to the low temperature -25°C
and high temperature +85°C for 30±2 minutes each
by 5 cycles and 1~2 hours recovery time under normal
temperature.
Rev 1.3
Siretta Ltd
Basingstoke Road
Spencers Wood
Reading
Berkshire RG7 1PW
sales
fax
email
web
[phone]
[phone]
[e-mail]
www.siretta.co.uk
1