STAC5-S-N120 Datasheet, PDF (1/7 Pages) List of Unclassifed Manufacturers – AC Advanced Microstep Drive

Applied Motion Products, Inc.
404 Westridge Dr.
Watsonville, CA 95076, USA
1-800-525-1609
Tel [phone]
Fax (831) 761-
6544
Product Datasheet
www.Applied-Motion.com
STAC5-S-N120
AC Advanced Microstep Drive
1pc. - 405.00
50pc. - 303.75
Product Features
Microstepping digital step motor driver in compact
package
Advanced anti-resonance algorithm
Torque ripple smoothing
Microstepping to 51,200 steps/rev
Operates from 120 VAC
Provides motor current up to 5 A/phase (peak of
sine) with idle current reduction
Fast 10/100 Ethernet for programming and
communications
Three pulse-based control modes: step & direction,
A/B quadrature, CW/CCW pulse
Velocity (oscillator) control mode with sophisticated
joystick operation
Streaming serial command mode (SCL) for
commands sent from a host controller
UDP & TCP support
4 digital inputs, 2 digital outputs, all optically
isolated
1 analog input, +/-10 volt range
Description
The STAC5-S-N120 stepper drive employs sophisticated current control designed for optimal smoothness over a
wide speed range. Anti-resonance, torque ripple smoothing, and microstepping work together to bring step motor
performance to a new high. To complement the drive Applied Motion offers a specially matched set of low-loss
NEMA 23 and 34 frame motors (see Related and Recommended Products below), all specifically designed with
high voltage operation in mind. Power to the drive comes from single-phase 120 VAC, and the drive can output up
to 5.0 A/phase (peak-of-sine) to the step motor. Protection features like over-voltage, over-temperature, and over-
current prevent damage while running in adverse conditions.
The STAC5-S-N120 can operate in pulse & direction, velocity, and streaming serial (SCL) control modes.
Selecting the control mode, setting up the motor, and configuring other drive parameters is done with the ST
Configurator™ software.
For connecting to external devices such as limit switches, proximity or photoelectric sensors, PLC I/O, lamps, and
other devices, the drive comes with 4 digital inputs, 2 digital outputs, and 1 analog input. The drive also features
an Ethernet port for configuration and communications. The Ethernet port is fast 10/100 Mbit, and the drive
supports both TCP and UDP communication protocols.