ST10-SI-NN Datasheet, PDF (1/8 Pages) List of Unclassifed Manufacturers – DC Advanced Microstep Drive w/ Si Programming

Applied Motion Products, Inc.
404 Westridge Dr.
Watsonville, CA 95076, USA
1-800-525-1609
Tel [phone]
Fax (831) 761-
6544
Product Datasheet
www.Applied-Motion.com
ST10-Si-NN
DC Advanced Microstep Drive w/ Si Programming
1pc. - 580.00
50pc. - 435.00
Product Features
Programmable microstepping drive with advanced
current control
100 lines of icon-based program capability
Si Programmer™ is heralded for its programming
ease
Animation mode displays operation in real time,
great for debugging
Wide current range 0.1 to 10.0 A/phase (peak of
sine) with idle current reduction
Advanced anti-resonance algorithm
Torque ripple smoothing
Microstepping and Microstep Emulation
8 digital inputs, 4 digital outputs, optically isolated
RS-232 cable and mating connectors included
Description
The ST10-Si-NN stepper drive is a DC-powered microstepping drive for controlling two-phase, bipolar step motors.
It offers advanced current control and a sophisticated 3rd generation anti-resonance algorithm that electronically
dampens motor and system resonances to improve motor smoothness and usable torque over a wide speed
range. The drive also employs electronic torque ripple smoothing and microstep emulation to greatly reduce motor
noise and vibration. The drive must be powered from 24-80 VDC and can output up to 10.0 A/phase (peak-of-
sine) to the step motor. Over-voltage, over-temperature and over-current protection features prevent damage while
running in adverse conditions. The drive is complemented by a specifically matched set of NEMA 23 and NEMA 34
frame stepper motors (see Related and Recommended products below).
The ST10-Si-NN can operate in all of the same control modes as the Q models, plus it has the ability to run a
stand-alone Si program stored in non-volatile memory. Si programs are created using the Si Programmer™
software, which provides unparalleled simplicity in indexer-drive programming via Applied Motion’s unique and
powerful icon-based programming environment. Preconfigured motor setup files included with Si Programmer™
make it easy to set up the drive for optimum results.
For connecting to external devices such as control signals, incremental encoders, limit switches, proximity or
photoelectric sensors, PLC I/O, lamps, and other devices, the drive comes with 8 digital inputs and 4 digital
outputs. Adjustable digital filters are present on the digital inputs for enhanced reliability in noisy environments.
Note: 2 single-ended analog inputs, which can be wired together as 1 differential analog input, are also available,
but not in Si program mode.
The drive comes with an RS-232 port for configuration and programming.
All ST drives are CE approved and RoHS compliant.