ST10-S Datasheet, PDF (1/8 Pages) List of Unclassifed Manufacturers – DC Advanced Microstep Drive

Applied Motion Products, Inc.
404 Westridge Dr.
Watsonville, CA 95076, USA
1-800-525-1609
Tel [phone]
Fax (831) 761-
6544
Product Datasheet
www.Applied-Motion.com
ST10-S
DC Advanced Microstep Drive
1pc. - 405.00
50pc. - 303.75
Product Features
Compact microstepping drive with advanced current
control
Step (pulse) & direction, CW/CCW pulse, or A/B
quadrature pulse control
On-board oscillator with analog speed reference
Versatile joystick operation
Streaming serial command mode (SCL)
Wide current range 0.1 to 10.0 A/phase (peak of
sine) with idle current reduction
Advanced anti-resonance algorithm
Torque ripple smoothing
Microstepping and Microstep Emulation
3 digital inputs, 1 digital output, optically isolated
1 analog input, 0-5 volt range
RS-232 cable and mating connectors included
Description
The ST10-S stepper drive is a DC-powered microstepping drive for controlling two-phase, bipolar step motors. It
offers advanced current control and a sophisticated 3rd generation anti-resonance algorithm that electronically
dampens motor and system resonances to improve motor smoothness and usable torque over a wide speed
range. The drive also employs electronic torque ripple smoothing and microstep emulation to greatly reduce motor
noise and vibration. The drive must be powered from 24-80 VDC and can output up to 10.0 A/phase (peak-of-
sine) to the step motor. Over-voltage, over-temperature and over-current protection features prevent damage while
running in adverse conditions. The drive is complemented by a specifically matched set of NEMA 23 and NEMA 34
frame stepper motors (see Related and Recommended products below).
The ST10-S can operate in the following control modes: step (pulse) & direction, velocity (oscillator), streaming
serial commands (SCL), and operation with an Applied Motion 4-axis or 8-axis SiNet Hub. All ST drives are setup
and configured using Applied Motion’s ST Configurator™ software. Preconfigured motor setup files included with
ST Configurator™ make it easy to set up the drive for optimum results.
For connecting to external devices such as step & direction control signals, incremental encoders, limit switches,
proximity or photoelectric sensors, PLC I/O, lamps, and other devices, the drive comes with 3 digital inputs, 1
digital output, and 1 single-ended analog input. Adjustable digital filters are present on the digital inputs for
enhanced reliability in noisy environments.
The drive comes with an RS-232 port for configuration, serial communications and programming.
All ST drives are CE approved and RoHS compliant.