SI5580 Datasheet, PDF (1/5 Pages) List of Unclassifed Manufacturers – AC Microstep Drive w/ Si Programming

Applied Motion Products, Inc.
404 Westridge Dr.
Watsonville, CA 95076, USA
1-800-525-1609
Tel [phone]
Fax (831) 761-
6544
Product Datasheet
www.Applied-Motion.com
Si5580
AC Microstep Drive w/ Si Programming
1pc. - 1,944.00
50pc. - 1,458.00
Product Features
Si Programmer™ compatible indexer/drive
AC input 110V or 220V switch selectable, 50-60 Hz
DC bus voltage 75 VDC full load, 80 VDC nominal
Software selectable motor current from 0.5-5.5
amps/phase
Software selectable microstep resolution and idle
current reduction
Eight optically isolated digital inputs
Four optically isolated digital outputs
RS-232 for PC/MMI communications
Pluggable screw terminal connectors
Dual MOSFET H-bridge, 3 state, pulse width
modulated amplifier switching at 20-30 kHz
Ideal for 4, 6 or 8 leaded step motors NEMA sizes
23 and 34
Over-temperature and over-current/short circuit
protection
Optional operator interface (MMI) allows users to
enter specific motion parameters
SCL mode for streaming serial commands from
host controller
Description
The Si5580 is a programmable stepper drive/indexer packaged in a rugged steel case. Integral heat sink, mounting
brackets, and mating connectors are included with each drive. The Si5580 is recommended for use with NEMA 23
and 34 frame step motors and comes with all operating software necessary to create a complete stepper motion
solution.
The Si5580 includes our Si Programmer™ software for quick set up and easy programming. Si programming is
ideal for stand-alone operation. For more experienced users with software development expertise, the Si5580 also
operates in SCL mode, which permits controlling the drive and motor by streaming serial commands from a host
PC or PLC, thus allowing the user to command all drive functions from the host software application.
Multiple axis applications are handled by our SiNet™ Hub multi-axis controllers and the SiNet Hub Programmer™
software application, which give users the ability to control up to 8 drives from a single program. You can also use
our MMI operator interface to allow machine operators to enter specific motion parameters.
Factory set for 110 VAC operation, the Si5580 can be set by the user for 220 VAC operation with a single switch.
Pluggable screw terminal blocks are provided for I/O, motor, and AC power connections. Mating connectors,
programming cable, and software are provided with each drive. The drive is protected from over-temperature
conditions as well as motor over-current and short circuit conditions.