|
SEU02G72D4BH2MT-30R Datasheet, PDF (1/16 Pages) List of Unclassifed Manufacturers – 2GB ECC DDR2 – SDRAM DIMM | |||
|
Data Sheet
Rev.1.2 03.01.2013
2GB ECC DDR2 â SDRAM DIMM
240 Pin ECC UDIMM
SEU02G72D4BH2MT-XXR
2GByte in FBGA Technology
RoHS compliant
Options:
ï§ Data Rate / Latency
DDR2 667 MT/s CL5
DDR2 533 MT/s CL4
Marking
-30
-37
ï§ Module Density
2048MB with 18 dies and 2 ranks
ï§ Standard Grade (TA)
(TC)
0°C to 70°C
0°C to 85°C
*) The refresh rate has to be doubled when 85°C<TC<95°C
Environmental Requirements:
ï§ Operating temperature (AMBIENT)
Standard Grade
0°C to 70°C
Grade W
-40°C to 95°C
ï§ Operating Humidity
10% to 90% relative humidity, noncondensing
ï§ Operating Pressure
105 to 69 kPa (up to 10000 ft.)
ï§ Storage Temperature
-55°C to 100°C
ï§ Storage Humidity
5% to 95% relative humidity, noncondensing
ï§ Storage Pressure
1682 PSI (up to 5000 ft.) at 50°C
Features:
ï§ 240-pin 72-bit Dual-In-Line Double Data Rate
synchronous DRAM Module with ECC support
ï§ VDD = 1.8V ±0.1V, VDDQ 1.8V ±0.1V
ï§ Auto Refresh (CBR) and Self Refresh 8k Refresh
every 64ms
ï§ 1.8V I/O ( SSTL_18 compatible)
ï§ Serial Presence Detect with EEPROM
ï§ Gold-contact pad
ï§ This module is fully pin and functional compatible to
the JEDEC PC2-5300 spec. and JEDEC- Standard
MO-237. (see www.jedec.org)
ï§ The pcb and all components are manufactured
according to the RoHS compliance specification
[EU Directive 2002/95/EC Restriction of Hazardous
Substances (RoHS)]
ï§ DDR2 - SDRAM component Micron
MT47H128M8CF-25 DIE-Rev.H
ï§ 128Mx8 DDR2 SDRAM in FBGA-60 package
ï§ Four bit prefetch architecture
ï§ DLL to align DQ and DQS transitions with CK
ï§ Multiple internal device banks for concurrent operation
ï§ Programmable CAS latency (CL)
ï§ Posted CAS additive latency (AL)
ï§ WRITE latency = READ latency â 1 tCK
ï§ Programmable burst length: 4 or 8
ï§ Adjustable data-output drive strength
ï§ On-die termination (ODT)
Figure: mechanical dimensions1
Swissbit AG
Industriestrasse 4
CH â 9552 Bronschhofen
Fon: +41 (0) 71 913 03 03
Fax: +41 (0) 71 913 03 15
1if no tolerances specified ± 0.15mm
www.swissbit.com
eMail: info@swissbit.com
Page 1
of 16
|
▷ |