English
Language : 

SEU01G72D4BH1MT-30R Datasheet, PDF (1/16 Pages) List of Unclassifed Manufacturers – 1GB ECC DDR2 . SDRAM DIMM
Data Sheet
Rev.1.1 03.01.2013
1GB ECC DDR2 – SDRAM DIMM
240 Pin ECC UDIMM
SEU01G72D4BH1MT-XXR
1GByte in FBGA Technology
RoHS compliant
Options:
 Data Rate / Latency
DDR2 667 MT/s CL5
DDR2 533 MT/s CL4
Marking
-30
-37
 Module Density
1024MB with 9 dies and 1 rank
 Standard Grade (TC)
(TA)
Grade W
(Tc)
(TA)
0°C to 85°C
0°C to 70°C
-40°C to 95°C
-40°C to 85°C
*) The refresh rate has to be doubled when 85°C<TC<95°C
Environmental Requirements:
 Operating temperature (ambient)
standard Grade
0°C to 70°C
Grade W
-40°C to 85°C
 Operating Humidity
10% to 90% relative humidity, noncondensing
 Operating Pressure
105 to 69 kPa (up to 10000 ft.)
 Storage Temperature
-55°C to 100°C
 Storage Humidity
5% to 95% relative humidity, noncondensing
 Storage Pressure
1682 PSI (up to 5000 ft.) at 50°C
Features:
 240-pin 72-bit DDR2 Dual-In-Line Double Data Rate
Synchronous DRAM Module with ECC support
 Module organization: single rank 128M x 72
 VDD = 1.8V ±0.1V, VDDQ 1.8V ±0.1V
 1.8V I/O ( SSTL_18 compatible)
 Serial Presence Detect (SPD) EEPROM
 Gold-contact pad
 This module is fully pin and functional compatible to the
JEDEC PC2-6400 spec. and JEDEC- Standard MO-237.
(see www.jedec.org)
 The pcb and all components are manufactured according
to the RoHS compliance specification
[EU Directive 2002/95/EC Restriction of Hazardous
Substances (RoHS)]
 DDR2 - SDRAM component Micron
MT47H128M8CF-25 DIE-Rev.H
 128Mx8 DDR2 SDRAM in FBGA-60 package
 Four bit prefetch architecture
 DLL to align DQ and DQS transitions with CK
 Eight internal device banks for concurrent operation
 Programmable CAS latency (CL)
 Posted CAS additive latency (AL)
 WRITE latency = READ latency – 1 tCK
 Programmable burst length: 4 or 8
 Adjustable data-output drive strength
 On-die termination (ODT)
Figure: mechanical dimensions1
Swissbit AG
Industriestrasse 4
CH-9552 Bronschhofen
Fon: +41 (0) 71 913 0303
Fax: +41 (0) 71 913 0315
1if no tolerances specified ± 0.15mm
www.swissbit.com
eMail: info@swissbit.com
Page 1
of 16