SC02MFA-SS Datasheet, PDF (1/16 Pages) List of Unclassifed Manufacturers – Drop Wire Clamps for CATV and Telephone Cable

A BELDEN BRAND
Diamond^® Drop Hardware
Drop Wire Clamps for CATV and Telephone Cable
Universal Messenger Cable Drop Wire Clamp
•• Permits cable to “float” free, fully protected from strain and chafing.
•• Drop clamp for the suspension of a messengered drop cable between the
pole, midspan and house.
•• For use with RG59, RG6 and other cables
•• Stainless steel bail wire and aluminum body.
Part Number Description
Installation:
1. Begin separation of the messenger wire from the
cable using the end-edge of the SC02MFA-SS Drop
Clamp.
Note: Never use a knife or other sharp tool to
separate messenger and cable.
2. Fit the cable and messenger wire into the SCO2MFA-
SS Drop Clamp as shown, so that the Clamp Bail is
between the two.
SC02MFA-SS
Universal Messenger Drop Wire Clamp
1
2
3. Grasp the separated end of the messenger and cable
with one hand and grip the Clamp Body, as shown,
with your other hand. Then, pull the SC02MFA-SS
3
back, in a straight line, separating the length of
messenger wire needed to make the wrap; about 15
to 18-inches.
4. Pull the messenger wire around the center of the
4
bearing surface as shown, toward the rear or drop-
side of the Clamp.
Note: If at the house end of the drop, this will be
done while tensioning or “sagging” the drop.
5. Pass the messenger wire through the “L” Slots and
5
begin the wrap about the SC02MFA-SS body, as
shown.
6. Continue the messenger wire wrap for two full turns.
7. Pass the messenger wire through the “L” Slot, as
6
shown, to the drop-side of the SC02MFA-SS and cut
the excess wire away, or ground it to the strand.
Note: For drop cable with larger messenger wire, one
wrap is sufficient. Wrap the end of the wire around
the end of the SC02MFA-SS and bring it back up the
“L” Slots, then cut away the excess, or ground it to
7
the strand.
Inner Outer
Pack Pack
--
125
6
A BELDEN BRAND
www.ppc-online.com
Customer Support: 800.800.6652