S16B-PUDSS-1 Datasheet, PDF (1/4 Pages) List of Unclassifed Manufacturers – 2.0mm pitch/Disconnectable Crimp style connectors

PUD CONNECTOR
2.0mm pitch/Disconnectable Crimp style connectors
This is a board-to-wire connector with
secure locking device that has been
designed to 2.0mm pitch, crimping style
and double-row. In spite of realizing low
insertion force, the stable electric
connection is demonstrated against the
condition such as vibration, pinching and
dry circuit. It is possible to unfasten the
locking even if the header is surrounded
with a case wall within height of header
because the tip of locking device in
receptacle does not protrude from its area.
• High reliability contact
• Superior operability
• Secure locking structure
• Polarizing key for mounting on PC board
Specifications –––––––––––––––––––
• Current rating: 3A AC, DC (AWG#22)
• Voltage rating: 250V AC, DC
• Temperature range: -25˚C to +85˚C
(including temperature rise in applying
electrical current)
• Contact resistance: Initial value/10m Ω max.
After environmental testing/20m Ω max.
• Insulation resistance: 1,000M Ω min.
• Withstanding voltage: 800V AC/minute
• Applicable wire: 001 type/AWG #26 to #22
002 type/AWG #28 to #24
* Compliant with RoHS.
* Refer to "General Instruction and Notice when using
Terminals and Connectors" at the end of this catalog.
* Contact JST for details.
Standards ––––––––––––––––––––––
0 Recognized E 60389
PC board layout (viewed from component side) and Assembly layout
Top entry type
Side entry type
^ʶ
"^ʶ
^ʶ
Even
number
circuits

ʢʣ

П

^Ê´


^ʶ
П
^Ê´

Odd
number
circuits
Circuit No.1
П
^Ê´

Connector outline

П

^Ê´

Note: 1.Tolerances are non-cumulative: ±0.05mm for all centers.
2. Hole dimensions differ according to the kind of PC board and piercing method.
The dimensions above should serve as a guideline. Contact JST for details.

^ʶ
Connector outline
"
^ʶ
Even number
circuits
Odd number
circuits
Circuit No.1
SMT type
"^ʶ
Even number circuits
^ʶ
NJO






Odd number circuits
Connector outline Circuit No.1
NJO
Note: 1.Tolerances are non-cumulative: ±0.05mm for all centers.
2.The dimensions above should serve as a guideline. Contact JST for details.
1