S1430UAP912 Datasheet, PDF (1/3 Pages) List of Unclassifed Manufacturers – Photoelectrics Amplifier, μ-Processor Controlled Type S1430 UAP, 3 Inputs/3 Transistor Outputs

Photoelectrics
Amplifier, µ-Processor Controlled
Type S1430 UAP, 3 Inputs/3 Transistor Outputs
• µ-Processor controlled
• Amplifier unit for 3 sets of photoelectrics
• 3 independent outputs
• NPN/PNP both NO or NC selectable
• Self-diagnostic functions
• Alignment failure indication
• Multivoltage 12 to 30 VAC/DC
• Modulated and synchronized light
• Adjustable sensitivity for each channel
• LED indications: supply, outputs, signal quality
• 11-pin plug-in housing
• For 115 or 230 VAC use power supplys from SS120-series
Product Description
Ordering Key
µ-Processor controlled ampli-
fier for 3 sets of photoelec-
tric sensors, type MOFTR,
MKFTR, MIFTR or MHFTR.
Utilising an 11-pin circular
plug for easy connection,
outputs freely selectable for
NPN/PNP or NO/NC. Self-
diagnostics for system test.
Protected against short-cir-
cuits, reverse wiring or cross
talk from adjacent photoelec-
trics. Multi-voltage power
supply. Sensitivity is indivi-
dually adjustable for each
set of photoelectrics.
Type
Special function
Output type
Power supply
S14 30 UAP 912
Type Selection
Plug type
Circular, 11 pins
Ordering no.
Supply: 12 - 30 VAC/DC
S 1430 UAP 912
Specifications
Rated operational voltage (UB)
pins 2 & 10
DC
10.8 to 33 VDC
AC
10.8 to 33 VAC, 45 to 65 Hz
Rated operational power
AC supply
DC supply
4 VA
3W
Power ON delay (tv)
< 300 ms
Output function
NPN and PNP switching
Make and break function
DIP-Switch selectable
Output current
Continuous (Ie)
Short-time (I)
100 mA per output
100 mA max.
Min. load current (Im)
0.5 mA
OFF-state current (Ir)
Max. 100 µA
Voltage drop (Ud)
≤ 3.5 VDC
Protection, outputs
Reverse polarity, short-circuit,
transients
Supply to photoelectric switch
Emitter
Supply voltage (open loop)
Current
Output resistance
Tx1: Pin 1
Tx2: Pin 9
Tx3: Pin 6
Shield: Pin 11 (common)
7 V square wave
≤ 300 mA short-circuit protected
10 Ω
Supply to photoelectric switch
(cont.)
Receiver
Rx1: Pin 4
Rx2: Pin 7
Rx3: Pin 8
Shield: Pin 5 (common)
Supply voltage (open loop) 5 VDC
Short-circuit current
10 mA
Input resistance
470 Ω
Sensitivity
(% of Sn)
Note:
• 2 ranges,
DIP-Switch selectable
- low sensitivity (25%)
- high sensitivity (100%)
• Sensitivity adjustment
with 270°:
Turn knob on CH 1, 2, 3
• Maximum range indi-
cated on photoelectric
switch data sheet in high
sensitivity range only
• Operation within low
sensitivity range, increa-
ses ambient light and
crosstalk immunity
Operating frequency (f)
Light/dark ratio 1:1
16 Hz
Specifications are subject to change without notice (25.06.99)
1