QS186LEQ8 Datasheet, PDF (1/8 Pages) List of Unclassifed Manufacturers – WORLD-BEAM QS186LE Laser Emitter

WORLD-BEAM QS186LE Laser Emitter
Datasheet
Class 1 and 2 lasers for use with Banner modulated photoelectric receivers
• Self-contained Class 1 or Class 2 modulated visible laser diode emitters
permit higher gain than LEDs and extended range in opposed-mode
sensing systems.
• Narrow effective beam provides small-object detection and precise
position control.
• Bright spot and multiple shapes provide great visual marking of objects.
• 10 to 30 V dc operation; third wire extinguishes laser light when
connected to +V correct dc.
Models
QS186LE
QS186LE10
QS186LE11
QS186LE12
QS186LE14
QS186LE2
QS186LE210
QS186LE211
QS186LE212
QS186LE214
Laser Class
Class 1
Class 2
Laser Spot Shape
Small Spot
Circle
Vertical Line
Horizontal Line
Cross
Small Spot
Circle
Vertical Line
Horizontal Line
Cross
Excess Gain at 15 m (50 ft) ¹
With receiver Q23SN6R: 7500
With receiver SM31RL: 340
With receiver QS18VN6R: 4500
With receiver VS3AN5R: 2100
With receiver VS2AN5R: 1100
-
-
-
-
With receiver Q23SN6R: 12200
With receiver SM31RL: 1200
With receiver QS18VN6R: 7000
With receiver VS3AN5R: 5500
With receiver VS2AN5R: 3600
-
-
-
-
Typical Beam Size
See Table 1 on page
2.
See Table 2 on page
3.
Standard 2 m (6.5 ft) cable models are listed. To order the 9 m (30 ft) cable model, add suffix "W/30" (QS18LE W/30). To
order the 4-pin Pico-style pigtail QD models, add suffix "Q" (QS18LEQ). To order the 4-pin integral Pico-style QD models,
add suffix "Q7" (QS18LEQ7). To order the 4-pin Euro-style QD pigtail models, add suffix "Q5" (QS18LEQ5). To order the 4-
pin integral Euro-style QD models, add suffix "Q8" (QS18LEQ8).
Models with a QD connector require a mating cable.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to
serious injury or death. This device does not include the self-checking redundant circuitry necessary
to allow its use in personnel safety applications. A sensor failure or malfunction can cause either an
energized or de-energized sensor output condition.
1 _{Not recommended for dusty or dirty environments; the scattered light would greatly reduce excess gain.}
Original Document
109415 Rev. H
27 March 2014
109415