Q58 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – Versatile mechanical design maximizes design flexibility

Q58 Series
High Power LED Driver
Total Power
60 Watts max.
Input Voltages
110 ~ 277VAC
Number of Outputs One
Preliminary
Product Specifications
ANZ#: Z214, January 30, 2014
SPECIAL FEATURES
 Universal Input range from 100VAC~304VAC, 50/60Hz
 Versatile mechanical design maximizes design flexibility.
 Size: XP: TBD / XM:108.3x76.3x30mm (LxWxH)
 Fully potted, suitable for dry and damp location applications
 4 in 1 Dimming Control plus “ENABLE” input
 UL8750 and CE compliant (pending)
 Wide selection of pre-adjusted C/C outputs (factory setting)
ENVIRONMENTAL
Operating temperature:
Storage temperature:
-40 to +50 ⁰ C, Tc: 80 ⁰ C
-40 to +85 ⁰ C
Humidity (Non-Condensing):
5% to 95%
Cooling:
Convection
Vibration Frequency:
5 to 50 Hz
MTBF: >100,000 Hours at full load and 25ºC ambient conditions
(TELC3 – Telcordia SR-332, Issue 3)
SPECIFICATIONS :
Input Range : 100 ~ 277VAC
Power Factor: > 0.92 at 65% to 100% load, 115VAC or 230VAC
Input Current : 0.72 Amps max. at 115VAC
Output Current Regulation : ±3%
Protection : OCP, SCP, OLP – Auto Recovery
Control : 0-10V dimmer; PWM (250-3KHz); Potentiometer; Enable
Hold up time: Half cycle min. at 120VAC and 80% rated load
MODEL SELECTION :
Model Number
Constant Voltage Mode
V (DC) A (mA) Max. W
Q58-U24-Xz
24, ±5%
2400
60
Q58-U36-Xz
36, ±5%
1600
60
Q58-U48-Xz
48, ±5%
1200
60
Notes:
1. “Xz” is optional - “Blank” = 5VA plastic case ; “Xp” =
94V-0 plastic case ; “Xm” = stud-mount metal case
1. yyyy = Output current
Dimming Wiring Diagram
Picture Not Available
Picture shown above is not to scale
Frequency : 47 to 63Hz
Inrush Current : 35.0 Amps max. at 230VAC, cold start 25^⁰C
Efficiency : 87% Typical
Maximum Power : 60W
Leakage Current : 50uA typ.
Dimension: TBD
Regulation Compliance: UL8750 or EN61347, EN55015, EN61547
Model Number
Q58-U24-Cyyyy-Xz
Q58-U30-Cyyyy-Xz
Q58-U36-Cyyyy-Xz
Q58-U42-Cyyyy-Xz
Q58-U48-Cyyyy-Xz
Q58-U54-Cyyyy-Xz
Q58-U72-Cyyyy-Xz
Constant Current Mode
A (mA) V (DC) Max. W
2650 ~ 1200 14 ~ 24
60
2100 ~ 1000 19 ~ 30
60
1780 ~ 800 23 ~ 36
60
1500 ~ 700 27 ~ 42
60
1350 ~ 600 30 ~ 48
60
1150 ~ 510 34 ~ 54
60
880 ~ 400
47 ~ 72
60
DIMMER
(sinking)
(-)
(+)
Maximum
current
output:
Typically
6mA.
DIMMER
(sourcing)
(-)
(+)
Maximum current
required: 1mA max
per LF1048 driver.
10K ohm (min)
potentiometer
PWM Controller
PWM
(250Hz~2KHz)
(-)
(+)
LED Driver
+V out
(RED)
-V out
(BLACK)
NC/CAP
+10V OUT
(YELLOW)
LED Driver
+V out
(RED)
-V out
(BLACK)
LED Driver
+V out
(RED)
-V out
(BLACK)
NC/CAP
+10V OUT
(YELLOW)
LED Driver
+V out
(RED)
-V out
(BLACK)
www.magtechind.com Tel: 702‐364‐9998
1 of 2