Q12 Datasheet, PDF (1/2 Pages) List of Unclassifed Manufacturers – UL8750 and CE compliant

Q12 Series
High Power LED Driver
Total Power
12 Watts max.
Input Voltages
110 ~ 277VAC
Number of Outputs One
Preliminary
Product Specifications
ANZ#: Z219, May 19, 2014
SPECIAL FEATURES
 Universal Input range from 100VAC~304VAC, 50/60Hz
 Versatile mechanical design maximizes design flexibility.
 Size: XP: TBD (LxWxH)
 Fully potted, suitable for dry and damp location applications
 4 in 1 Dimming Control plus “ENABLE” input
 UL8750 and CE compliant (pending)
 Wide selection of pre-adjusted C/C outputs (factory setting)
ENVIRONMENTAL
Operating temperature:
Storage temperature:
-40 to +50 ⁰ C, Tc: 80 ⁰ C
-40 to +85 ⁰ C
Humidity (Non-Condensing):
5% to 95%
Cooling:
Convection
Vibration Frequency:
5 to 50 Hz
MTBF: >100,000 Hours at full load and 25ºC ambient conditions
(TELC3 – Telcordia SR-332, Issue 3)
SPECIFICATIONS :
Input Range : 100 ~ 277VAC
Power Factor: > 0.92 at 65% to 100% load, 115VAC or 230VAC
Input Current : 0.25 Amps max. at 115VAC
Output Current Regulation : ±3%
Protection : OCP, SCP, OLP – Auto Recovery
Control : 0-10V dimmer; PWM (250-3KHz); Potentiometer; Enable
Hold up time: Half cycle min. at 120VAC and 80% rated load
MODEL SELECTION :
Model Number
Constant Voltage Mode
V (DC) A (mA) Max. W
Q12-U12-XP
12, ±5%
1000
12
Q12-U24-XP
24, ±5%
500
12
Q12-U36-XP
36, ±5%
335
12
Q12-U48-XP
48, ±5%
850
12
Notes: yyyy = Output current
“z” = P for plastic or M for metal enclosure
Dimming Wiring Diagram
Picture Not Available
Picture shown above is not to scale
Frequency : 47 to 63Hz
Inrush Current : 25.0 Amps max. at 230VAC, cold start 25^⁰C
Efficiency : 87% Typical
Maximum Power : 12W
Leakage Current : 50uA typ.
Dimension: XP: TBD (LxWxH)
Regulation Compliance: UL8750 or EN61347, EN55015, EN61547
Model Number
Q12-U12-Cyyyy-Xz
Q12-U24-Cyyyy-Xz
Q12-U30-Cyyyy-Xz
Q12-U36-Cyyyy-Xz
Q12-U42-Cyyyy-Xz
Q12-U48-Cyyyy-Xz
Q12-U54-Cyyyy-Xz
Constant Current Mode
A (mA) V (DC) Max. W
1300 ~ 1000 6 ~ 12
12
675 ~ 500
14 ~ 24
12
540 ~ 400
19 ~ 30
12
450 ~ 335
23 ~ 36
12
385 ~ 285
27 ~ 42
12
360 ~ 250
30 ~ 48
12
300 ~ 220
34 ~ 54
12
DIMMER
(sinking)
(-)
(+)
Maximum
current
output:
Typically
6mA.
DIMMER
(sourcing)
(-)
(+)
Maximum current
required: 1mA max
per LF1048 driver.
10K ohm (min)
potentiometer
PWM Controller
PWM
(250Hz~2KHz)
(-)
(+)
LED Driver
+V out
(RED)
-V out
(BLACK)
NC/CAP
+10V OUT
(YELLOW)
LED Driver
+V out
(RED)
-V out
(BLACK)
LED Driver
+V out
(RED)
-V out
(BLACK)
NC/CAP
+10V OUT
(YELLOW)
LED Driver
+V out
(RED)
-V out
(BLACK)
www.magtechind.com Tel: 702‐364‐9998
1 of 2